Determination of Titanium Isotopes in Rutiles with High Spatial Resolution by Femtosecond Laser Ablation Multi-Collector Inductively Coupled Plasma Mass Spectrometry

Hong Liu,Wen Zhang,Zhengbin Deng,Zhaochu Hu,Martin Schiller,Martin Bizzarro,Yongsheng Liu,Tao Luo,Yantong Feng,Lanping Feng

DOI: https://doi.org/10.1016/j.sab.2023.106646

2022-01-01

Abstract:Crystallization of Fe-Ti oxides can induce significant Titanium (Ti) isotope fractionation during magmatic differentiation. As such, rutile (TiO2), a common Ti-rich mineral present in igneous, metamorphic, and sedi-mentary rocks, can serve as a tracer of the geologic processes. A new method to determine the Ti mass-dependent isotope fractionation of rutiles with high precision and high spatial resolution was developed using femtosecond laser ablation multi-collector inductively coupled plasma mass spectrometry (fs-LA-MC-ICP-MS). A high sensi-tivity cone combination (Standard sampler cone + X skimmer cone) can increase the Ti signals, which permits ablation of rutiles with a low ablation frequency of 1 Hz and analysis with high spatial resolution. However, a signal smoothing device is necessary to overcome the signal fluctuation issue that commonly occurs in the modern low-dispersion ablation cell at a low ablation frequency. Our results show that changing laser parameters (spot size and laser fluence) or signal mismatch between samples and references would bias toward higher delta 49Ti values (0.16%o to 0.59%o) in dry plasma, which can be suppressed by using wet plasma conditions instead. After these optimizations, the spatial resolution of our method at horizontal-and vertical-axis can be promoted to 10 mu m and approximate to 4 mu m, respectively, meanwhile ensuring accurate delta 49Ti results with a precision of +/- 0.10%o. The long-term measurements of a rutile USA75 by fs-LA-MC-ICP-MS show a good reproducibility of delta 49Ti (+/- 0.11%o). Measurements of 9 natural rutile crystals by both solution MC-ICP-MS and fs-LA-MC-ICP-MS provide consistent delta 49Ti values, confirming the robustness of our fs-LA-MC-ICP-MS method. A significant variation of delta 49Ti (up to approximate to 2.94%o) among the 12 rutiles was observed, indicating that Ti isotopes in rutiles can be a useful geochemical tracer. Four rutile crystals (e.g., USA75, Bra12, Sco2 and Bra6) are shown to be homogeneous in delta 49Ti within an uncertainty of <0.13%o and can therefore serve as reference materials for future in situ Ti isotope ratios measurement.