Rutile in the UHP eclogites from the CCSD main drillhole (Donghai, eastern China): Trace-element geochemistry and metallogenetic implications.

RC Wang,S Wang,JS Qiu,P Ni
DOI: https://doi.org/10.3969/j.issn.1000-0569.2005.02.020
IF: 1.468
2005-01-01
Acta Petrologica Sinica
Abstract:Rutile is a common Ti-bearing accessory mineral in eclogites. In the 100 similar to 2000m borehole samples of the Chinese Continental Scientific Drilling Project, rutile appears more or less in rutile eclogite, phengite eclogite and kyanite eclogite. It is mainly included in major metamorphic minerals, or as intergranular grains between them. When eclogite suffered amphibolite-facies retrograde metamorphism, rutile was often retrograded to produce sphene aureole. Apart from the major components, trace elements such as Nb, Cr and Zr are measured by electron microprobe with specific operating conditions. Rutiles contain on average 147ppm Nb with the maximum 670ppm, while the average Cr content is 614ppm with the maximum value of 3630ppm. Overall, low Nb concentrations in rutile (< 1000ppm) indicate a mafic source-rock for the eclogites. Additionally, three types of eclogites are also distinguishable on the basis of their Nb, Cr concentrations. Rutiles from the rutile eclogites display low Cr (< 500ppm) and variable Nb contents (0 similar to 670ppm), and those from the phengite eclogites are characterized by moderate Cr (500 similar to 1200ppm) and also variable Nb (0 similar to 480ppm). Rutiles from kyanite eclogites are diagnostic, being highly enriched in Cr (2000 similar to 3630ppm) but very poor in Nb (< 140ppm). Although Zr is very low in rutile, most of Zr contents range between 150 and 240ppm with an average of 200ppm. The highest Zr contents of each samples is used to estimate formation temperature of rutiles, based on a new Zr-in-rutile geothermometer proposed by Zack et al. (2004), which vary from 690 degrees C to 787 degrees C. The study shows that trace-element geochemistry can serve as a potential tool for provenance of eclogites and for estimation of temperature of associated Ti mineralization.
What problem does this paper attempt to address?