Abstract:Light guiding is used to direct light from an emitting source to a different location. It is frequently realized through a clad-core structure with a difference in the refractive index of the materials. This paper explores the possibility of combining a fluoropolymer (THV) film of low refractive index, serving as a cladding layer, with a polycarbonate (PC) core, via injection molding. Pristine THV lacks adherence to the PC. However, when treated with O2 plasma prior to overmolding, bonding can be established that was quantified in peel tests. The effect of this surface treatment was further investigated by adjusting the plasma treatment duration and time to overmolding. Furthermore, parameter studies comprising the four molding parameters, namely packing pressure, injection speed, melt temperature, and mold temperature, were performed. Numerical injection molding simulations assessed the prevailing temperatures at the PC-THV boundary. Consequently, the temperature-time integral could be calculated and linked with the measured peel strengths by fitting a proportionality constant. While the plasma treatment duration showed minor influence, the activation diminished with time, halving the measured peel loads within 24 h. The adhesion was experimentally found to increase with a lower packing pressure, faster injection speed, and higher melt and mold temperature. Those same molding relations influencing the peel loads were also found with the temperature-time integral when scaled by the proportionality constant in the simulations (R2=85%). Apparently, adhesion is added by molding settings which promote higher interface temperatures that prevail for longer. Hereby, the faster injection speed increases the melt temperature through shear heating. A higher packing pressure, in contrast, presumably increases the heat transfer at the PC-THV interface, accelerating the cooling. The measured peel loads were 0.3-1.6 N/mm for plasma-treated samples and nearly zero for pristine THV.

Study on Simulation and Application of Automotive Interior Polycarbonate Film Thermoforming Technology

A study on the influence of thermoforming process on the optical properties of polycarbonate films

Experimental and numerical study on the viscoelastic property of polycarbonate near glass transition temperature for micro thermal imprint process

Polymer Composite Thermoforming: Ultrasonic-Assisted Optimization for Enhanced Adhesive Performance in Automotive Interior Components

Numerical simulation of tensile performance of polymers

Experimental investigations of uniaxial and biaxial cold stretching within PC‐films and bars using optical measurements

Study of Elastic Modulus and Yield Strength of Polymer Thin Films Using Atomic Force Microscopy

Simulation and Experimental Study on Enhancing Dimensional Accuracy of Polycarbonate Light Guides

Infrared Thermographic Evaluation of Thermal Release Phenomena in Polycarbonate During Plastic Deformation

Study of Dynamic Failure Behavior of a Type of PC/ABS Composite

Study on Thermal Conducting Insulating Polycarbonate and Polycarbonate/abs Polymers

Experimental and Modeling Study of the Compressive Behavior of PC/ABS at Low, Moderate and High Strain Rates

Comparison of the Tensile Performance of Polymer PC and PC/ABS

Study on the Forming Process Parameters of Automobile Front Panel Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

Experimental and numerical investigations on thermoforming of thermoplastic prepregs of glass fiber reinforced nylon 6

Characterization of the surface properties and adhesion behavior of electroplated PC/ABS using nano-indentation and scratch tests

Influence of Injection Molding Parameters on the Peel Strength between Plasma-Treated Fluoropolymer Films and Polycarbonate

Large tensile deformation behavior of PC/ABS alloy

Experimental Research of Automotive Needlepunched Carpets at Thermoforming Temperatures

Experimental Investigation of the Viscoelastic Deformation of PC, ABS and PC/ABS Alloys

Research on Temperature and Strain Rate Dependent Viscoelastic Response of Polyvinyl Butaral Film