Abstract:The strain rate, temperature, and microstructure-dependent, tensile-yielding behavior of three semi-crystalline polymers, namely high-density polyethylene (HDPE), polyamide 6 (PA6) and low-density polyethylene (LDPE), was investigated. It is found that, depending on the strain rate and temperature, the three polymers exhibit markedly different tensile deformation behavior, especially the shape of the stress-strain curves. LDPE exhibits a uniform extension and shows no obvious geometrically unstable effect, such as necking, during the overall tensile process. HDPE and PA6, on the other hand, show clear necking and cold-drawing phenomena during the uniaxial tensile process. When considering the effect of strain temperature on necking, significant differences between HDPE and PA6 emerge. For both, the heterogeneous necking disappears and homogeneous deformation occurs with increasing temperature. For HDPE, the homogeneous deformation takes place in the vicinity of the melting temperature, while for PA6, it takes place close to the glass transition temperature instead. The conventional yield point, corresponding to the force maximum in stress-strain curves, becomes less defined as the testing temperature is increased. It is applicable, to some extent, to combine the Brereton analysis and Considère construction to predict such a point quantitatively. However, this combination can only be suitable for homogeneously deformed material. In addition, it is found that the special, double yielding behavior will take place under certain deformation conditions for all three semi-crystalline polymers. With respect to judging the appearance of the double yielding of polymers, it seems that it can be estimated qualitatively by plotting the compression residual strain-applied strain curves of the samples.

Numerical simulation of tensile performance of polymers

Comparison of the Tensile Performance of Polymer PC and PC/ABS

Large tensile deformation behavior of PC/ABS alloy

Effect of cyclic loading on tensile properties of PC and PC/ABS

Rate-dependent Large Deformation Behavior of PC/ABS

Experimental Investigation and Modeling of the Mechanical Behavior of PC/ABS During Monotonic and Cyclic Loading

Deformation Response and Constitutive Modeling of PC, ABS and PC/ABS Alloys under Impact Tensile Loading

A Constitutive Model for Strain Hardening Behavior of Predeformed Amorphous Polymers: Incorporating Dissipative Dynamics of Molecular Orientation

Investigation of Tensile Deformation Behavior of PC, ABS, and PC/ABS Blends from Low to High Strain Rates

Experimental and Modeling Study of the Compressive Behavior of PC/ABS at Low, Moderate and High Strain Rates

Investigation on the Tensile Property of Pc/Abs Polymer

The Application of DIC Method in the Investigation of Polymer Tensile Behaviors

Experimentation And Modeling Of The Tension Behavior Of Polycarbonate At High Strain Rates

Effect of Triaxial Stress Constraint on the Deformation and Fracture of Polymers

Experimental Study on Dynamic Mechanical Behaviors of Polycarbonate

Investigation of Viscoelastic Deformation and Constitutive Modeling of PC, ABS and PC/ABS Alloys

Tensile and Fracture Behaviors of Pc/Abs Polymer Alloy

Viscoelastic–Viscoplastic Cyclic Deformation of Polycarbonate Polymer: Experiment and Constitutive Model

Study of Elastic Modulus and Yield Strength of Polymer Thin Films Using Atomic Force Microscopy

Numerical Implementation of Strain Rate Dependent Thermo Viscoelastic Constitutive Relation to Simulate the Mechanical Behavior of PMMA

Investigation on Tensile Deformation Behavior of Semi-Crystalline Polymers