Abstract:Polycarbonate is a widely used ductile glassy polymer that can undergo large strain deformation before failure. During the plastic deformation process, some mechanical energy is converted to heat, which, if the specimen is loaded at rates sufficient that the heat cannot conduct out of the material, can result in significant temperature rises that affect the mechanical response. Typically, this is expected to result in a reduction in stress at large strain, compared to the behaviour under isothermal conditions; however, compared to other glassy polymers, it has been observed that less softening than expected is experienced in polycarbonate at high strain rates. The current paper describes a thorough investigation of temperature rises in polycarbonate. Compression experiments are performed using a screw-driven machine, a hydraulic machine, and a long split Hopkinson bar, all instrumented with a high-speed infrared camera to measure temperature rises at strain rates between 0.01 and 2600 s -1 at a starting temperature around 20°C. Further, temperature rises in compression experiments at 0.5 s -1 and starting temperatures between -80 to 150°C are measured using embedded thermocouples. These span the range of the secondary- to glass-transitions of polycarbonate, allowing investigation of the effect of these transitions. These experiments are supported by finite element simulations, which use a phenomenological viscoplastic model, to ensure the thermal boundary conditions are adiabatic. Temperature rises are observed in both temperature and rate-dependent tests: experiments at higher strain rates and lower temperatures experience a greater temperature rise because of the higher yield stress; however, there are differences in the conversion ratio between plastic work and heat (Taylor Quinney coefficient), which is both temperature and rate dependent, and strongly affected by both the secondary and glass transitions.

Experimentation And Modeling Of The Tension Behavior Of Polycarbonate At High Strain Rates

Tension testing of polycarbonate at high strain rates

High Strain-Rate Tensile Experiment on Polycarbonate Bar

Experimental investigation and modeling of the tension behavior of polycarbonate with temperature effects from low to high strain rates

Tensile behavior of polycarbonate over a wide range of strain rates

Experimental and Modeling Study of the Compressive Behavior of PC/ABS at Low, Moderate and High Strain Rates

Deformation Response and Constitutive Modeling of PC, ABS and PC/ABS Alloys under Impact Tensile Loading

A Constitutive Model for Strain Hardening Behavior of Predeformed Amorphous Polymers: Incorporating Dissipative Dynamics of Molecular Orientation

Investigation of Tensile Deformation Behavior of PC, ABS, and PC/ABS Blends from Low to High Strain Rates

Experimental Study of Mechanical Properties of CFRP under Different Strain Rates and Temperatures

Numerical simulation of tensile performance of polymers

Effects of strain rate and temperature on the tension behavior of polycarbonate

Rate-dependent Large Deformation Behavior of PC/ABS

Dynamic Tensile Behavior of Polyamide 6 at Different Strain Rates: Experiments and Constitutive Model

Deformation of PC/ABS alloys at elevated temperatures and high strain rates

Effect of cyclic loading on tensile properties of PC and PC/ABS

Experimental and Modelling of Constitutive Equation of Polycarbonate Material

Thermomechanical coupling during large strain deformation of polycarbonate: Experimental study

Comparison of the Tensile Performance of Polymer PC and PC/ABS

Large tensile deformation behavior of PC/ABS alloy

Modeling the Rate-Dependent Ductile-Brittle Transition in Amorphous Polymers