Abstract:The biaxial fatigue test of wind turbine blades is helpful to shorten the test time and is more suitable for the actual operating conditions. Adding tuning masses to the blade is a common method for blade uniaxial testing at present, and its purpose is to adjust the load distribution in one direction of the blade. However, the tuning masses on the blade will affect the load distribution in the direction of the blade flap-wise and edge-wise at the same time in the biaxial test, so the concept of "virtual masses" is proposed to realize the decoupling of the load distribution in the biaxial test. Due to the limitation of the size of the virtual mass mechanism and the complex motion trajectory of the blade, the actual inertial effect provided by the virtual masses is different from the ideal situation, which will affect the resonance characteristics of the test system and the load distribution of the blade. Therefore, in order to evaluate the effect of the nonlinear effect introduced by the virtual masses on the resonance characteristics of the test system and the blade load distribution, the equivalent dynamic model of the bladed virtual mass test system was established by using the Lagrange method. Then, the nonlinear effects of blade amplitude and virtual mass installation parameters on the test system are obtained by a numerical method. Then, based on the nonlinear vibration theory, the approximate nonlinear amplitude–frequency characteristics of the test system are obtained, that is, the resonance frequency of the test system will decrease with the increase in the blade amplitude. Through the simulation analysis of two blades over 80 m in length, the applicability of the theoretical method is verified. It can be seen from the simulation results of the simulated uniaxial test that larger amplitudes of the blade and shorter connection rods will reduce the resonance frequency of the test system. When the vibration amplitude at the excitation point is the same, a lower resonance frequency results in a smaller load distribution level, that is, the area which is actually fully tested will be reduced. In the biaxial simulation test, the resonance frequency of the test system will be further reduced because the virtual masses will be affected by the coupled motion in both directions at the same time. Furthermore, the introduction of an external mechanism of the virtual mass will also cause deformation of the envelope of the blade biaxial trajectory, which will further affect the load distribution of the blade. This work explores the nonlinear influence of virtual masses on the actual fatigue test. The theoretical analysis is helpful to provide the basis and reference for the preliminary preparation work of the test organization, including adjusting the tuning mass scheme, adjusting the load distribution and selecting the appropriate excitation equipment.

A Vision-Based Displacement Measurement Method of Wind Turbine Blades in Biaxial Fatigue Testing

Variational Mode Decomposition-Based Multirate Data-Fusion Framework for Estimating Structural Dynamic Displacement by Integrating Vision- and Acceleration-Based Measurements

A morphological filtering-based strain data processing method for biaxial fatigue testing of wind turbine blades

Vision-based Structural Displacement Measurement: System Performance Evaluation and Influence Factor Analysis

A Vision-Based System for Dynamic Displacement Measurement of Long-Span Bridges: Algorithm and Verification

Multiaxial Strain Analysis in Large Wind Turbine Blades under Full-scale Fatigue Testing

Multi-Point Displacement Monitoring of Bridges Using A Vision-Based Approach

Damage Mode Identification of Composite Wind Turbine Blade under Accelerated Fatigue Loads Using Acoustic Emission and Machine Learning

Image-Based Structural Dynamic Displacement Measurement Using Different Multi-Object Tracking Algorithms

Vision and Vibration Data Fusion-Based Structural Dynamic Displacement Measurement with Test Validation

Full-Field Dynamic Strain on Wind Turbine Blade Using Digital Image Correlation Techniques and Limited Sets of Measured Data From Photogrammetric Targets

Noncontact structural dynamic characteristics identification method and its test verification

A NEW APPROACH TO THE DETECTION OF FATIGUE DAMAGE IN RAILS USING PIEZOMAGNETIC EFFECTS

Research on rapid calculation method of wind turbine blade strain for digital twin

Load Distribution Optimization Method for Fatigue Test of Full-scale Structure of Biaxial Resonant Wind Turbine Blade

Dynamic Strain Distribution Monitoring and Fatigue Damage Analysis on a 100 kW Wind Turbine Blade Based on Field Aerodynamic Measurements

Establishing a robust testing approach for displacement measurement on a rotating horizontal-axis wind turbine

Structural Health Monitoring of Wind Turbine Blade Using Fiber Bragg Grating Sensors and Fiber Optic Rotary Joint

Identification of Structural Dynamic Characteristics Based on Machine Vision Technology

Nonlinear vibration characteristics of virtual mass systems for wind turbine blade fatigue testing

A Vision‐based Surface Displacement/strain Measurement Technique Based on Robust Edge‐enhanced Transform and Algorithms for High Spatial Resolution