Hardware Reconfigurable Near Infrared Wavelength Modulated Methane Sensor and Its Application (Invited)
Shi Yuechong,Li Yafei,Song Fang,Zheng Chuantao,Wang Yiding
DOI: https://doi.org/10.3788/gzxb20235210.1052407
IF: 0.6
2023-01-01
ACTA PHOTONICA SINICA
Abstract:At present, the demand for gas sensors is moving towards miniaturization, low power consumption and networking. Among them,laser absorption spectroscopy has wide application prospects in related fields with advantages of fast detection speed,high accuracy,good stability,and long service life. However, the commonly used laser gas sensor system is generally large in size,high in power consumption and high in cost,which is difficult to be widely used as a gas sensor node. Therefore,it is urgent to develop a new spectroscopy gas sensing system with small volume,low power consumption and low cost to promote the application of laser gas sensing technology in "carbon neutralization". Based on the above social needs,we developed a hardware reconfigurable Wavelength Modulation Spectroscopy (WMS) methane sensor. Based on the characteristics of Field Programmable Gate Array (FPGA) hardware algorithm acceleration, the hardware-based wavelength modulation gas absorption spectroscopy analysis algorithm, realizes quasi- synchronous output of scan signal and harmonic signal amplitude as well as on-chip integration of WMS with a delay time of only 4.05 ms. The on-chip logic circuit is mainly divided into WMS analysis module and WMS drive signal generation module. Based on Direct Digital Synthesis(DDS)technology,the WMS drive signal generation module is used to generate sine wave and triangular wave signals required by WMS,and both signal frequency and phase can be tuned in a wide range,which can flexibly control the sensor operation according to an enabling signal. The core of WMS analysis module is an orthogonal phase-locked amplifier. This work focuses on enhancing the hardware reconfigurability to enhance the flexibility of the sensor system. Only when the enabling signal is in high level, the WMS analysis module and the drive signal generation module start to work,which lays the foundation for intermittent work,scanning signal alignment,and gas absorption fixed point analysis. The feasibility of the intermittent work is verified by the actual measurement. The system has a unified sampling clock,and an onchip clock generation unit based on external reference signals is constructed. On the basis of avoiding the frequency offset problem, the flexible reconstruction of the system sampling clock is realized. A standard orthogonal signal generation module based on DDS technology is established to realize the generation of standard orthogonal signals at any frequency. Combined with the characteristics of finite impulse response filter that the frequency response can be reconstructed by modifying parameters,the phase-locked analysis at any target frequency is realized. The on-chip system logic part is developed in hardware logic language as a whole,and there is no problem of " program runaway". After the design of the system logic part,the software simulation is carried out to verify the accuracy of the system logic function. In order to verify the linearity of harmonic signal extraction of the designed hardware reconfigurable wavelength modulation methane sensor,a sinewave verification experiment is carried out. By analyzing the amplitude extraction results of different standard sinewave signals, a step output of the system under different inputs is observed, and a linear response with a goodness of fit of 99.99% is obtained. The measured sinewave amplitude fluctuation range is about +/- 0.5 mV. In order to verify the actual sensing performance of the methane sensor, methane experiments are carried out using a Herriot gas cell with an optical path length of 25 m and a laser with a central wavelength of 2 334 nm for targeting the absorption line of methane at 4 284.5 cm(-1). It can be seen from the experimental results that the gas detection linearity of the methane sensor is 99.97%. The stability analysis shows that the sensor resolution is better than 25 parts-per- million in volume (ppmv),and the response time is similar to 4.9 s. In addition,the Allan variance results show that when the integration time is 0.5 s, the detection limit of the sensor is 7.8 ppmv. Methane leakage test is carried out. Through the analysis of the measured CH4 concentration levels when CH4 leakage occurs,the detection ability of the sensor for methane leakage is proved. Compared with the existing methane sensor based on software architecture,the extremely low data delay lays a foundation for intermittent work,and provides the possibility to realize the application of node-type low-power gas detection. At the same time,the sensor has high accuracy,fast response speed,and can be used flexibly and conveniently based on actual needs. The developed sensor shows a good application prospect with high electronic integration based on FPGA.