Abstract:Attosecond science is one of the driving forces for developing the femtosecond amplifiers of high average power and ultrashort pulse duration. In this work, the regenerative amplification is studied experimentally and theoretically based on Yb:CaYAlO4 crystal for the practical needs of high-repetition-rate attosecond light sources. In the theoretical study, a mode-tunable regenerative cavity with good thermal stability is designed based on the thermal lens calculations of Yb:CaYAlO4 crystal; the amplified output energy and spectra of π and σ polarization of the crystal are calculated. In the experiment, the π-axis of Yb:CaYAlO4 crystal is parallel to the laser polarization, and the laser amplifier emits 1.61 mJ pulses with average power 16.1 W. Notably, the dip of the π-polarization emission spectrum near 1025.1 nm compensates for the gain narrowing of the seed laser during amplification. Thus, the center wavelength and the spectral full width at a half maximum of the amplified laser are 1030 nm and 16 nm respectively. Using a grating-pair for compression, 149 fs pulses with peak power 9.5 GW are obtained. In comparison, the σ-polarization emission spectrum of Yb:CaYAlO4 crystal is relatively flat in a range from 1000 to 1050 nm, but with a larger gain cross-section. When the laser polarization is parallel to the σ-axis of Yb:CaYAlO4 crystal, 2.87 mJ pulses at 10 kHz repetition rate are achieved, with an average power of 28.7 W. In this case, the center wavelength and the spectral full width at half maximum of the amplified laser are 1037 nm and 11 nm respectively. Using a grating-pair for compression, 178 fs pulses with peak power of 14.2 GW are obtained. The beam quality factor measured is 1.09 along the x-axis of the amplified laser and 1.17 along the y-axis. To the best of our knowledge, this is the highest average power and the maximum pulse energy obtained from the Yb:CaYAlO4 amplifier. For applications in high-repetition-rate attosecond light sources, terahertz generation and optical parametric amplification, subsequent laser outputs with average power 200 W, pulse energy 20 mJ and pulse duration less than 200 fs are expected to be achieved by adding two stages of traveling-wave amplification.

Demonstration of a petawatt-scale optical parametric chirped pulse amplifier based on yttrium calcium oxyborate

High-efficiency Amplification of Non-Principal Plane of Yttrium Calcium Oxyborate

Degenerated Optical Parametric Chirped-Pulse Amplification with Cesium Lithium Borate.

High average power amplification of femtosecond pulses based on the Yb:CaYAlO4 crystal

Broadening and Amplification of an Infrared Femtosecond Pulse for Optical Parametric Chirped-Pulse Amplification

Optical Parametric Chirped Pulse Amplification Based on Photonic Crystal Fibre

Broadband Main OPCPA Amplifier at 808 Nm Wavelength in High Deuterated DKDP Crystals

Experimental demonstration on 400 nm-scale bandwidth optical parametric chirped-pulse amplification based on mixed cascaded crystals

Quasi-parametric amplification of chirped pulses based on a Sm 3+ -doped yttrium calcium oxyborate crystal

High-power chirped pulse amplification based on Yb-doped rod-type PCF and nonlinear amplifying loop mirror oscillator

Toward 5.2 Mu M Terawatt Few-Cycle Pulses Via Optical Parametric Chirped-Pulse Amplification With Oxide La3ga5.5nb0.5o14 Crystals

High average power amplification of femtosecond pulses based on the Yb:CaYAlO_4 crystal

Energetic picosecond 10.2-μm pulses generated in a BGGSe crystal for nonlinear seeding of terawatt-class CO2 amplifiers

Gain Measurement of ZnGeP2 Optical Parametric Oscillator Pulses in a High-Pressure CO2 Amplifier

Photonic Crystal Fiber Based Wavelength-Tunable Optical Parametric Amplifier and Picosecond Pulse Generation

Yb:CaYAlO<sub>4</sub> Regenerative Amplifier

Demonstration of Optical Parametric Gain Generation in the 1 Μm Regime Based on a Photonic Crystal Fiber Pumped by a Picosecond Mode-Locked Ytterbium-Doped Fiber Laser

Large Size Sm-doped YCOB Crystal Grown by Bridgman Method for QPCPA Application

Hundreds of picosecond pulses amplifier based on Yb-doped tapered fiber for the generation of 100 W average output power

A CW Seeded Femtosecond Optical Parametric Amplifer

CEP-Stable, Few-Cycle, kHz OPCPAs for Attosecond Science: Energy Scaling and Coherent Sub-Cycle Pulse Synthesis