Abstract:The dynamics simulation of multibody systems (MBS) using spatial velocities (non-holonomic velocities) requires time integration of the dynamics equations together with the kinematic reconstruction equations (relating time derivatives of configuration variables to rigid body velocities). The latter are specific to the geometry of the rigid body motion underlying a particular formulation, and thus to the used configuration space (c-space). The proper c-space of a rigid body is the Lie group SE(3), and the geometry is that of the screw motions. The rigid bodies within a MBS are further subjected to geometric constraints, often due to lower kinematic pairs that define SE(3) subgroups. Traditionally, however, in MBS dynamics the translations and rotations are parameterized independently, which implies the use of the direct product group $SO\left( 3\right) \times {\Bbb R}^{3}$ as rigid body c-space, although this does not account for rigid body motions. Hence, its appropriateness was recently put into perspective. In this paper the significance of the c-space for the constraint satisfaction in numerical time stepping schemes is analyzed for holonomicaly constrained MBS modeled with the 'absolute coordinate' approach, i.e. using the Newton-Euler equations for the individual bodies subjected to geometric constraints. It is shown that the geometric constraints a body is subjected to are exactly satisfied if they constrain the motion to a subgroup of its c-space. Since only the $SE\left( 3\right) $ subgroups have a practical significance it is regarded as the appropriate c-space for the constrained rigid body. Consequently the constraints imposed by lower pair joints are exactly satisfied if the joint connects a body to the ground. For a general MBS, where the motions are not constrained to a subgroup, the SE(3) and $SO\left( 3\right) \times {\Bbb R}^{3}$ yield the same order of accuracy.

Comparison of long time simulation of hamilton and lagrange geometry dynamical models of a multibody system

Geometric Deviation Modeling by Kinematic Matrix Based on Lagrangian Coordinate

Modeling And Simulation Of Space Manipulator Based On Lie Group

Dynamics calculation and simulation of flexible multi-body system based on null-space method

New Algorithm for Solving Euler-Lagrange Equations of Multibody System Dynamics

Modeling and Simulation of an Underactuated Double Rotating Pendulums System

A Lie group variational integrator in a closed-loop vector space without a multiplier

ADVANCES IN THE NUMERICAL METHODS FOR LAGRANGE'S EQUATIONS OF[1.4mm］ MULTIBODY SYSTEMS

Reducing the Constrained Multibody Dynamics Problem to the Solution of a System of ODEs via Velocity Partitioning and Lie Group Integration

Screw and Lie group theory in multibody dynamics

A multisymplectic Lie algebra variational integrator for flexible multibody dynamics on the special Euclidean group SE (3)

Multi-Body Dynamics Modeling and Simulation of Maglev Satellites

Evaluation and implementation of Lie group integration methods for rigid multibody systems

Dynamic Modeling and Simulation of a Rotational Inverted Pendulum

Analytical Study on the Motions Around Equilibrium Points of Restricted Four-Body Problem

The significance of the configuration space Lie group for the constraint satisfaction in numerical time integration of multibody systems

Comparison and application analysis of classical relative motion models

Chaotic dynamics analysis of double inverted pendulum with large swing angle based on Hamiltonian function

Multi-body system expression in Modelica based on Cartesian method

Dynamic Modeling and Numeration of Flexible Multi-Body System with Closed Loop

Symmetric structures and dynamic analysis of a (2+1)-dimensional generalized Benny-Luke equation