Abstract:Laminated/bimetal composites can offer the advantage of combining constituent metals, but their heterogeneous microstructures exhibit different mechanical properties during subsequent remanufacturing process than those of the homogeneous counterparts. This study investigated the tensile properties, microstructural evolution and deformation behaviours of a new explosive welded TA1/5083 composite sheet using the in-situ characterisation. It is found that a wavy transition zone forms in the composite sheet, showing gradients in the element diffusion and micro-hardness adjacent to the interface. The slip bands with the tensile direction of 45° primarily occur in the 5083 side (rather than the TA1 side) with an increase in deformation. Although the dislocation density of the grains in the 5083 layer increases significantly, these grains are slightly elongated along the tensile direction without a significant orientation change. Three deformation stages and a subsequent crack initiation stage appear during the in-situ tensile process. The initiation of micro-cracks in the interfacial zone results from the internal stress concentration occurring at the bottom of interfacial wave structure. Once initial micro-cracks evolve into the intermetallic compounds (IMCs) of the interfacial zone, the high magnitude of stress concentrations of the TA1 and 5083 layers leads to necking and sequential fractures. This study can provide a reference for the design of high-quality Ti/Al composite components for industry.

Fabrication and Microstructure Evolution of Novel Laminated TiAl Composite

Fabrication of Fully Dense Tial-Based Composite Sheets with A Novel Microlaminated Microstructure

PREPARATION AND PROPERTIES OF TiB2/TiAl COMPOSITE SHEETS WITH LAYERED STRUCTURE

Growth Kinetics of TiAl3 Layer in Multi-Laminated Ti–(TiB2/Al) Composite Sheets During Annealing Treatment

Design a novel TiAl/Ti2AlNb laminated composite with high toughness prepared by foil-foil metallurgy

Balancing the strength and ductility of Ti2AlC/TiAl composite with a bioinspired micro-nano laminated architecture

Fabrication, microstructure and compressive properties of Ti2AlC/TiAl composite with a bioinspired laminated structure

Fabrication, microstructure and mechanical properties of TiAl matrix composite reinforced by submicro/nano-Ti 2 AlC

Microstructure, solidification behavior and mechanical properties of Al-Si-Mg-Ti/TiC fabricated by selective laser melting

Mechanism of Preparing Laminar Composite Using Ti-Based Amorphous Alloy

Microstructure and Mechanical Properties of Ti-Al-Ti-Ti2AlNb Laminated Composites Based on the Ductile-brittle Structure

Design a Ti6Al4Vâ€“Ti43Al9V laminated composite with high strength and fracture toughness

In-situ synthesis of Al2O3-reinforced high Nb–TiAl laminated composite with an enhanced strength-toughness performance

Micro-/nano-scale structure and elemental diffusion in the Al/Ti/Al sandwich structure

Strengthening and toughening of laminated TiAl composite sheets by titanium alloy layers and carbide particles

In-situ investigation on tensile properties of a novel Ti/Al composite sheet

In-Situ Observation of Fracture Behavior of Ti-Aluminide Multi-Layered Composites Produced by a Hybrid Sintering Process

Fabrication of Al/Al-TiB 2 laminate composites via hot press sintering process: An insight into the mechanical properties and fracture behavior

Microstructure and Phase Evolution of Ti-Al-C-Nb Composites Prepared by In Situ Selective Laser Forming

Tailoring Ultrafine Grained and Dispersion-Strengthened Ti2AlC/TiAl Composite Via a New Fabrication Route

Reaction mechanism and microstructure evolution of superhigh strength in-situ TiC/Ti composite based on Cr 2 AlC-Ti system