Abstract:This paper presents an AlN-based piezoelectric micromachined ultrasonic transducer (PMUT) with a double-beam suspended structure. In order to obtain greater deflection displacement and output sound pressure compared to standard systems, a suspended structure is proposed, achieved by utilizing double-sided deep reactive ion etching of the silicon substrate. This structure is capable of greatly reducing the tensile stress caused by deflection on the membrane edge, thereby improving the piezoelectric micromachined ultrasound transducer performance. Simulations are performed using the finite element method and COMSOL software, with results demonstrating that the suspension structure exhibits a lower resonant frequency and a larger membrane deflection displacement than other methods, implying higher penetration and acoustic energy levels. Thus, the sound pressure is improved by changing the PMUT structure. Moreover, a PMUT with a double-beam is fabricated, and the impedance diagram is determined with an impedance analyzer. The resonant frequency of the transducer was 31.88 kHz, while the sound wave received by the standard lead zirconate titanate (PZT) ultrasonic transducer was converted to a voltage of 277.5 mV. In comparison, the proposed PMUT demonstrates an improved acoustic emission performance. In addition, the electromechanical coupling coefficient of the suspended PMUT is observed to be approximately 3.08%, which is significantly better than that of a fully clamped PMUT. This demonstrates the strong electromechanical conversion performance of the proposed PMUT. Results from the transmission and reception air experiments prove that the proposed double-beam PMUT can potentially be used for ranging and wireless energy transmission applications.

Performance Improvement of High Frequency Aluminum Nitride Ultrasonic Transducers

Simulation and Optimization of Piezoelectric Micromachined Ultrasonic Transducer Unit Based on AlN

Enhanced high-frequency piezoelectric ultrasonic transducer based on integrated AlN honeycomb structure

Design and Fabrication of High-Performance Piezoelectric Micromachined Ultrasonic Transducers Based on Aluminum Nitride Thin Films

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Transducer design for AlN Lamb wave resonators

Fabrication Process and Performance Analysis of AlN Based Piezoelectric Micromachined Ultrasonic Transducer with a Suspended Structure.

Ultrahigh Frequency Ultrasonic Transducers Design with Low Noise Amplifier Integrated Circuit

Design and Fabrication of High-Frequency Piezoelectric Micromachined Ultrasonic Transducer Based on an AlN Thin Film

Preparation, Characterization, and Application of AlN/ScAlN Composite Thin Films

Design, Fabrication, Characterization, and Simulation of AlN-Based Piezoelectric Micromachined Ultrasonic Transducer for Sonar Imaging Applications

Performance of Aluminum Nitride-Based Piezoelectric Micromachined Ultrasonic Transducers under Different Readout Configurations

Alumina/epoxy Nanocomposite Matching Layers for High-Frequency Ultrasound Transducer Application

High Voltage Excitation And Nonlinear Transmission Of A 16 Mhz Aln-Based Piezoelectric Micro-Machined Ultrasonic Transducer

Design, fabrication, and evaluation of high frequency, single-element transducers incorporating different materials

3D FEM Analysis of High-Frequency AlN-Based PMUT Arrays on Cavity SOI

Enhancing Ultrasonic Echo Response of AlN Thin Film Transducer Deposited by RF Magnetron Sputtering

Enhancement of the Transmission Performance of Piezoelectric Micromachined Ultrasound Transducers by Vibration Mode Optimization

An Aln-Based Piezoelectric Micro-Machined Ultrasonic Transducer (Pmut) Array

Intelligent Optimization Design of a Phononic Crystal Air-Coupled Ultrasound Transducer

An Aln-Based Piezoelectric Micromachined Ultrasonic Transducer with a Double-Beam Suspended Structure