Study on the Influence of Ultrasonic Impact Treatment (UIT) on Stress Evaluation of Laser Cladding Coating by Using Metal Magnetic Memory Technology

Bin Liu,Peng Fu,Jiayang Gu,Peng He,Jinxiang Fang,Lihong Dong

DOI: https://doi.org/10.1016/j.engfailanal.2022.106936

IF: 4

2022-01-01

Engineering Failure Analysis

Abstract:The effect of ultrasonic impact treatment (UIT) on stress of laser cladding coating evaluated with metal magnetic memory technology (MMMT) was discussed, so a stress control method was proposed. In this paper, a metal magnetic memory testing device of EMS-2003, a two-channel pen metal magnetic memory probe and a non-ferromagnetic three-dimensional electronically controlled displacement plat form were employed to collect Hp(y) signal defined as the normal component of MMM signal, and tensile test was carried out on LC-50 testing machine. To prove the theoretical analysis, the microstructure and three dimensional surface topography of coating under different repetition rates of UIT were observed by using optical microscope and laser scanning confocal microscopy. The results show that the influence of detection line on Hp(y) signal can be ignored, and the distribution of Hp(y) signals under different tensile loads are all approximately an oblique line, which can be explained by the magnetic dipole model. As tensile load increases, the magnetic field intensity gradient of Hp(y) signal (K) becomes higher, and after coating is in the plastic deformation state, the value of K becomes lower gradually as tensile load increases further. When tensile loads are the same, the value of K becomes higher gradually as the repetition rate of UIT increases. But as repetition rate of UIT increases, the slope of K becomes lower gradually, and the changes on microstructure and deformation caused by UIT are seen as main reasons. At last, the experimental results were theoretically discussed based on the magnetostriction effect, and it was thought that the change on orientation of magnetic domain was the main reason.