Abstract:This paper presents an experimental and theoretical study of surface generation in the ultra-precision grinding of hard and brittle materials. The study takes into account the material properties, the relative vibration between the grinding wheel and the workpiece, the machining parameters and the phase shift of the grinding process. The Taguchi approach is employed to study the influence of machining parameters on the surface quality and shows that the feed speed and rotational speed of the workpiece are key factors. Experiments have been conducted to study individual variables, and the results further show that the feed rate and the cross-feed distance have a significant effect on surface generation. It is found that the spirals around the central area of the workpiece are the primary mechanism for surface generation, which originates from the synchronous relative tool-work vibration. The integral part of the ratio of the rotational speed of the grinding wheel to rotational speed of the workpiece determines the number of spirals and its fractional part controls the spiral geometry. A theoretical model for predicting the single spiral generation has been developed to explain the accumulation of the phase shift and the geometry. The changeable feed speed near the end of grinding is also modelled, revealing the approximate straight lines around one circle in the central region. The simulated results indicate that the theoretical models and the ground surfaces are in close agreement. The scallop-height model is developed to calculate the influence of phase shift on surface quality, and it is found that the phase shift near the medium value can effectively improve surface quality. Finally, a comparison of different surface generation mechanisms in grinding mould steel, tungsten carbide (WC) and reaction bonded silicon carbide (RB-SiC) is made. It is interesting to note that the Spanzipfel effect contributes to the surface generation not only on ductile materials such as mould steel but also on brittle materials such as WC and RB-SiC. The Spanzipfel effect is the most significant in grinding mould steel. For WC and RB-SiC, the ground surface contains both a ductile region and a brittle region in the form of micro-fractures.

Theoretical and Experimental Investigations of Surface Generation Induced by Ultrasonic Assisted Grinding

Study on Grinding Force Model in Ultrasonic Vibration Assisted Grinding for Ductile Materials

Study on the system matching of ultrasonic vibration assisted grinding for hard and brittle materials processing

Effect of Ultrasonic Vibration Assisted Grinding Process on Surface Topography and Properties of C/SiC Composite

Research on the System Matching Model in Ultrasonic Vibration-Assisted Grinding

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

An Experimental Investigation on Ultrasonic Vibration-Assisted Grinding of Sio2f/Sio2 Composites

Generation Mechanism Modeling of Surface Topography in Tangential Ultrasonic Vibration-Assisted Grinding with Green Silicon Carbide Abrasive Wheel

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

Modeling and experimental study of surface generation in ultrasonic vibration-assisted grinding of Ti-6Al-4V micro-channels

Mechanism study on ultrasonic vibration assisted face grinding of Hard and brittle materials

Multi-Step Two-Dimensional Ultrasonic-Assisted Grinding of Silicon Carbide: An Experimental Study on Surface Topography and Roughness

Study on surface formation mechanism of multiple abrasive particles under ultrasound

A grinding force model in two-dimensional ultrasonic-assisted grinding of silicon carbide

Surface roughness model of ultrasonic vibration-assisted grinding GCr15SiMn bearing steel and surface topography evaluation

An experimental and theoretical analysis of surface generation in the ultra-precision grinding of hard and brittle materials

Numerical modeling of material removal mechanism and surface topography for gear profile grinding

An experimental investigation of system matching in ultrasonic vibration assisted grinding for titanium

Grinding force modeling in ultrasonic-assisted face grinding of ZrO2 ceramics and influence of grinding wheel wear on its accuracy

Towards understanding the ploughing friction mechanism in ultrasonic assisted grinding with single grain