Abstract:<p>Interstitial-free (IF) steel with ultrafine-grained (UFG) size was used to clarify the underlying mechanisms of the 'extra-hardening' behavior from the Hall-Petch plot and the discontinuous yielding behavior from axial tensile tests. Using transmission electron microscopy (TEM) at different tensile strains, it was found that the TEM micrographs for the bulk sample of the UFG IF steel showed a decrease in dislocation density in the grain interior after experiencing a micro tensile strain of 1.0 % before macro-yielding. Additionally, an increase in dislocation density was found in the grain interior, with a micro tensile strain of 15 % in the necking region after macro-yielding. In-situ compression tests in a TEM for micropillars were performed to directly observe the motion of dislocations and corresponding interactions with grain boundaries in UFG IF steel. Before macro-yielding, pre-existing dislocations in the grain interior moved toward the grain boundary, wherein they were then absorbed. The dislocation density decreased significantly due to the annihilation, which was accompanied by an increase in load during pre-yielding. The decrease in dislocation density in the grain interior of the micropillar is consistent with the results obtained from the bulk sample. After macro-yielding, the burst-like dislocation emission emerged from the grain boundary, leading to a yield drop and a discontinuous yielding behavior. Furthermore, the higher yield stress and the yield drop in the UFG IF steel can be understood by the decrease in dislocation density according to a combination of the Orowan model as well as the Johnston-Gilman model.</p>

Synergetic Strengthening from Dynamic Slip Band-Grain Boundary Interaction in a Low-Density FeMnAlC Steel

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

Dynamic Compression and Constitutive Model in Fe-27Mn-10Al-1C Duplex Lightweight Steel

Dynamic Compressive Mechanical Behavior and Microstructure Evolution of Rolled Fe-28Mn-10Al-1.2C Low-density Steel

Unusual grain-size effects on tensile deformation behavior of twinning-induced plasticity steel with low Mn content

Excellent dynamic properties and corresponding deformation mechanisms in a microband-induced plasticity steel with dual-heterogeneous structure

Unusual step-like stress flow behavior and mechanisms of a 1.3 GPa grade medium-Mn steel with 51.2 % ductility

Microstructure-Based Multiscale Modeling of Deformation in MarBN Steel under Uniaxial Tension: Experiments and Finite Element Simulations

Micromechanism involved in ultrafine grained ferrite/martensite dual phase steels strengthened by nanoscale Cu-rich precipitates

Synergistic Effect of Al and Ni on Microstructure Evolutions and Mechanical Properties of Fe-Mn-Al-C Low-Density Steels

Grain size gradient effect on grain boundary mediated deformation of nano-grained metals

Microstructures, hot tensile deformation behavior and constitutive modeling in a superlight Mg-2.76Li-3Al-2.6Zn-0.39Y alloy

Formation mechanism of κ -carbides and deformation behavior in Si-alloyed FeMnAlC lightweight steels

Synergistic grain boundary engineering for achieving strength-ductility balance in ultrafine-grained high-Cr-bearing multicomponent alloys

Microstructure-Based Modeling of Deformation in Steels Based on Constitutive Relationships from Micropillar Compression

Mechanical response of dislocation interaction with grain boundary in ultrafine-grained interstitial-free steel

Effect of Grain Size on the Plastic Deformation Behaviors of a Fe-18Mn-1.3Al-0.6C Austenitic Steel

Study on Dynamic Deformation Behavior of Q&P Steel with Heterogeneous Ultrafine-Grain Ferrite Matrix

Tensile Behaviors and Strain Hardening Mechanisms in a High-Mn Steel with Heterogeneous Microstructure

Atomistic investigation of the mechanical and tribological responses of the ferrite-cementite interface with a Bagaryatskii orientation

Composition-dependent slip planarity in mechanically-stable face centered cubic complex concentrated alloys and its mechanical effects