Abstract:Background. Metal implants can produce heat and damage adjacent tissues under microwave irradiation, which makes local metal implants in the body a contraindication for microwave therapy. However, with the wide application of titanium alloy implants which have low permeability and low conductivity, this concept has been challenged. Our team members have confirmed through previous research that continuous low-power microwave irradiation does not cause thermal damage to the surrounding tissues of the titanium alloy. Is there any other way to further increase the dose of microwave irradiation while reducing the heat production of titanium alloy implants? In this study, the effect of TiO2 nanofilm on reducing the heat production of titanium alloy implants in microwave field was verified by animal experiments, and the effect of TiO2 nanofilm on fracture healing was observed. Methods. 30 rabbits were selected. In the experiment of temperature measurement, 10 rabbits were randomly divided into experimental group (n=5) and control group (n=5), and the contralateral lower limb of the rabbits in experimental group was set as the sham operation group. The right femurs in the experimental group were implanted with Ti6Al4V plates coated with TiO2 nanofilm, and the right femurs in the control group were implanted with common titanium alloy plates without TiO2 nanofilm. The same surgical procedure was used in the sham operation group, but no plate was implanted. The temperature of the deep tissue above the metal implant was measured with an anti-interference thermocouple thermometer during 20 minutes of microwave irradiation. The other 20 rabbits were randomly divided into two groups, experimental group (n=10) and control group (n=10). The femoral shaft fracture models were established again. Ti6Al4V plates coated with TiO2 nanofilm and common titanium alloy plates were implanted in the two groups, respectively, and both groups were exposed to continuous microwave irradiation with a power of 40 W or 60 W for 30 days after operation. The fracture healing was evaluated by X-ray at 0 day, 14 days, and 30 days after microwave irradiation, respectively. The animals were sacrificed at 30 days after operation for histopathological assessment. Results. The temperature in the experimental group, control group, and sham operation group increased significantly after 40 W and 60 W microwave irradiation (2.18±0.15°C~6.02±0.38°C). When exposed to 40 W microwave, the temperature rise of the control group was 4.0±0.34°C, which was significantly higher than that of the experimental group 2.82±0.15°C (P<0.01) and the sham operation group 2.18±0.33°C (P<0.01). There was no significant difference in temperature rise between the experimental group and the sham operation group (P=0.21). When exposed to 60 W microwave, the temperature rise of the control group was 6.02±0.38°C, which was significantly higher than that of the experimental group 3.66±0.14°C (P<0.01) and sham operation group 2.96±0.22°C (P<0.01), and there was no significant difference between the experimental group and the sham operation group (P=0.32). X-ray evaluation showed that there was no significant difference in callus maturity between the experimental group and the control group at 14 days (P=0.554), but there was significant difference in callus maturity between the two groups at 30 days (P=0.041). The analysis of bone histologic and histomorphometric data at 30 days was also consistent with this. Conclusion. Under the animal experimental condition, compared with the common titanium alloy implant, the TiO2 nanofilm can reduce the heat production of the titanium alloy implant in the 2450 MHz microwave field and has no adverse effect on fracture healing. This study opens up a promising new idea for the application of microwave therapy to metal implants in human body.

Sol-gel dip-coated TiO<sub>2</sub> nanofilms reduce heat production in titanium alloy implants produced by microwave diathermy

Study on TiO2 Nanofilm That Reduces the Heat Production of Titanium Alloy Implant in Microwave Irradiation and Does Not Affect Fracture Healing

A Titanium Dioxide Nano Film Encapsulation for Metal Orthopedic Implants in Diathermy Rehabilitation Therapy

Efficiently Reduced Heat Rise in TiO2 Coating Ti-based Metallic Implants Using Anodic Oxidation Method

The observation of low or middle power microwave radiation on tissues adjacent to titanium alloy implants

Low dose of continuous – wave microwave irradiation did not cause temperature increase in muscles tissue adjacent to titanium alloy implants – an animal study

Biocompatibility and Microstructure-Based Stress Analyses of TiNbZrTa Composite Films

Thermal Effects of 2450 Mhz Microwave Exposure Near A Titanium Alloy Plate Implanted in Rabbit Limbs

Effects of different doses of microwave therapy on adjacent tissue of titanium alloy implants after fracture surgery

Magnesium-incorporated sol-gel Ta2O5 coating on Ti6Al4V and in vitro biocompatibility

Effects Of Surface Nanocrystallization Of Titanium Alloy On Biological Behavior Of Osteoblast

Effect of Different Heat Treatment Temperatures on Micro/Nano Grade Porous Structure Films of Treated Titanium Metal

Effects of low-dose microwave on healing of fractures with titanium alloy internal fixation: an experimental study in a rabbit model

Fe-NC Nanozymes-Loaded TiO2 Nanotube Arrays Endow Titanium Implants with Excellent Antioxidant Capacity for Inflammation Inhibition and Soft Tissue Integration

Nanoscale surface modification by anodic oxidation increased bone ingrowth and reduced fibrous tissue in the porous coating of titanium-alloy femoral hip arthroplasty implants.

Enhanced osteogenesis of titanium with nano-Mg(OH)2 film and a mechanism study via whole genome expression analysis

TEM Analysis and in Vitro and in Vivo Biological Performance of the Hydroxyapatite Crystals Rapidly Formed on the Modified Microarc Oxidation Coating Using Microwave Hydrothermal Technique

Optimizing alkaline hydrothermal treatment for biomimetic smart metallic orthopedic and dental implants

In-situ construction of the nanostructured TiO 2 /TiN composite films by induction heat treatment: Improved mechanical, corrosion, and biological properties

A Water-Based Biocoating to Increase the Infection Resistance and Osteoconductivity of Titanium Surfaces

Atomic layer deposited TiO2 nanofilm on titanium implant for reduced the release of particles