Numerical Simulation of Substrate Roughness on the Interface Bonding of Cold-sprayed Ti6Al4V

Jiang Shengwei,Zhou Hongxia,Li Xueting,Wang You

DOI: https://doi.org/10.11933/j.issn.1007-9289.20211112001

2022-01-01

China surface engineering

Abstract:In the process of cold spraying, the roughness of the substrate affects interface bonding between the coating and the substrate. At present, little attention is paid to this issue, and there still exists certain disputes. Took the process of cold spray repairing Ti6Al4V titanium alloy (TC4 for short) as the research object, by using finite element simulation method, two-dimensional and three-dimensional single particle impact models with different roughness are established, and the changes in interface temperature, particle equivalent plastic strain and system energy when the particle impacted on smooth, ground and grit blasted surfaces are analyzed. The following conclusions are drawn: As the substrate roughness increases, the equivalent plastic strain and flattening ratio of the particle gradually decreases; The interface temperature and equivalent plastic strain are higher at the "wave peak" and lower at the "trough" of the substrate. Under high roughness, the plastic deformation of the particles is weakened while the rebound tendency of the particles is enhanced. Therefore, for the cold-sprayed TC4 repair processing, the roughening of the substrate is not conducive to the bonding of the coating and the substrate. The results provide theoretical guidance for substrate pretreatment in the process of repairing titanium alloy by cold spraying.