Abstract:So far, numerical models in the Eulerian frame have proven effective in investigating deformation behaviors and predicting critical velocities of cold sprayed deposits. Although the previously developed thin parallel-sliced model from the center of a particle could significantly reduce the calculation time under the satisfied calculation accuracy, the assumed model is associated with an infinitely long cylinder instead of a sphere, thus making the output unreal. In this study, a new slice model was developed. The newly established model can not only provide accurate predictions of deformation characteristics but also reduce computational cost to 14 % as compared to the 1/4 particle model. Key issues of deformation characteristics and critical velocities concern tuned preheated temperatures of Ni particle and Ni substrate over the varied particle sizes. If a Ni particle with a diameter of 20, 40 and 60 μm is used, similar deformation morphologies with different maximum PEEQ and temperatures are obtained. This is so because the mesh resolution proportionally scales with the particle size. In the cases of either of preheated particle and substrate, or both, the deformation of particle and substrate is accordingly increased due to the thermal softening. The requirements for obtaining a series of critical velocities in cold sprayed different materials are elucidated, in particular regarding Zn of 340 m/s, Cu of 380 m/s, Fe of 450 m/s, Ni of 470 m/s, Al of 550 m/s, Ti of 650 m/s and In718 of 660 m/s. The achieved knowledge could be also be transferred to cold spraying simulation of multiple particle impacts.

Modeling on Deformation Behavior of Al Particles Impacting on Al Substrate and Effect of Surface Oxide Films on Interfacial Bonding in Cold Spraying

Numerical Simulation of Deformation Behavior of Al Particles Impacting on Al Substrate and Effect of Surface Oxide Films on Interfacial Bonding in Cold Spraying

Particle-based Simulation of Cold Spray: Influence of Oxide Layer on Impact Process

Numerical Analysis of Deformation Behavior and Interface Bonding of Ti6Al4V Particle after Subsequent Impact During Cold Spraying

Effect of particle oxidation, size and material on deformation, bonding and deposition during cold spray: a peridynamic investigation

Effect of Parameters of Cold Sprayed Cu Particles on Its Impacting Behavior

Modeling Aspects of High Velocity Impact of Particles in Cold Spraying by Explicit Finite Element Analysis

Simulation of Effect of Interface Evolution on the Bonding During the High-Velocity Particle Impacts in Cold Spray by Using Eulerian Approach

Study on Impact Fusion at Particle Interfaces and Its Effect on Coating Microstructure in Cold Spraying

A Numerical Approach to Study the Oxide Layer Effect on Adhesion in Cold Spray

Interfacial structure between particles in an aluminum deposit produced by cold spray

Effect of the Powder Particle Structure and Substrate Hardness During Vacuum Cold Spraying of Al2O3

Prediction of deformation characteristics and critical velocities during cold-spray: A new 3D model

Significant influences of metal reactivity and oxide films at particle surfaces on coating microstructure in cold spraying

Effect of Spray Angle on Deposition Characteristics in Cold Spraying

Experimental and Numerical Study of Al2219 Powders Deposition on Al2219-T6 Substrate by Cold Spray: Effects of Spray Angle, Traverse Speed, and Standoff Distance

Simulation of Deposition Behavior of Bulk Amorphous Particles in Cold Spraying

Towards Better Understanding Supersonic Impact-Bonding Behavior of Cold Sprayed 6061-T6 Aluminum Alloy Based on a High-Accuracy Material Model

Capturing cold-spray bonding features of pure Cu from in situ deformation behavior using a high-accuracy material model

Bonding mechanisms in cold spray deposition of gas atomised and solution heat-treated Al 6061 powder by EBSD

Interfacial metal/ceramic bonding mechanism for metallization of ceramics via cold spraying