Abstract:Excessive burning of fossil fuels for energy production has led to an exponential increase in CO 2 concentrations in the atmosphere, which is the core of universal problems such as global warming and climate change. One of the new approaches to reducing CO 2 emissions is to think of CO 2 as a useful raw material and convert this compound into useful products. Moreover, electrocatalytic carbon dioxide reduction (eCO 2 R) can be conveniently utilized to establish a zero-emission carbon cycle and utilize this CO 2 for energy-dense fuels and other chemical raw materials [1]. However, exploring novel catalysts is the ultimate need of the hour for an effective and efficient eCO 2 R. Heterogeneous single-atom catalysts (SAC) containing isolated metal species on an atomic level are gaining the increasing attention of the scientific community owing to their high metal utilization sites and superior catalytic properties[2]. The SACs are put into the full effect of catalysis by scattering it over conductive support. Therefore, in this work, the copper SACs are supported over a unique porphyrin-based graphdiyne (SAC-PG) with a π-conjugated structure (Figure 1). Graphdiyne possesses two acetylenic linkages between the aromatic rings and is responsible for not only displaying exceptional electronic conductivity but when coupled with the metalloporphyrin network provides numerous active sites for catalysis[3]. This SAC-PG analogue is achieved by a Glaser-Hay coupling reaction on Cu foam or foil. Moreover, SEM analysis is performed in combination with SEM-EDX and elemental mapping to investigate the morphology of the fabricated catalyst (Figure 2). In addition, this unique copper-based SAC-PG is evaluated as a catalyst for eCO 2 R in a customized H-cell with 0.1M/0.5M KHCO 3 as an electrolyte and Pt as a counter electrode. Nafion 117 proton exchange membrane is used for separation between the cathodic and anodic compartments while an Ag/AgCl (3M KCl) was used as a reference electrode. Under these eCO 2 R conditions, the copper SAC-PG catalyst displayed extremely high current densities (32 – 75 mA/cm 2 ) over a range of voltages (1.0-1.2 V vs RHE) and acceptable faradaic efficiencies for the carbon products (with maximum FE over 60% in total for all carbon products). In conclusion, a 2D metal covalent organic framework containing a repeating unit of Cu-porphyrin linked by butadiyne linkages was established. This unique structure showed effective CO 2 R catalysis due to its nanoporous structure, high electronic conductivity, and abundant metal cites utilization. Further optimization and constriction of these easily adjustable catalysts open up various possibilities of further exploration in the field of eCO 2 R. Acknowledgement : The author Zubair Masaud acknowledges support from the Norwegian Micro- and Nano-Fabrication Facility (NorFab, No. 245963/F50) The author Hao Huang acknowledges Marie Skłodowska-Curie Actions individual fellowship CarbonChem 101024758. References [1] I. Ganesh, “Electrochemical conversion of carbon dioxide into renewable fuel chemicals - The role of nanomaterials and the commercialization,” Renew. Sustain. Energy Rev. , vol. 59, pp. 1269–1297, 2016, doi: 10.1016/j.rser.2016.01.026. [2] X. Yang, A. Wang, B. Qiao, and J. U. N. Li, “Single-Atom Catalysts : A New Frontier,” vol. 46, no. 8, 2013. [3] C. Huang et al. , “Progress in Research into 2D Graphdiyne-Based Materials,” Chem. Rev. , vol. 118, no. 16, pp. 7744–7803, 2018, doi: 10.1021/acs.chemrev.8b00288. Figure 1

Electronic Perturbation of Copper Single‐Atom CO2Reduction Catalysts in a Molecular Way

Mixed-valence Palladium Single-Atom Catalyst Induced by Hybrid TiO2-graphene Through a Photochemical Strategy

Regulating Electronic Structure of Single-Atom Catalysts toward Efficient Bifunctional Oxygen Electrocatalysis.

Electronic Perturbation of Cu Nanowire Surfaces with Functionalized Graphdiyne for Enhanced CO2 Reduction Reaction

Regulating efficient and selective single‐atom catalysts for electrocatalytic CO2 reduction

Cu Single-Atom Electrocatalyst on Nitrogen-Containing Graphdiyne for CO2 Electroreduction to CH4

Insights on forming N,O-coordinated Cu single-atom catalysts for electrochemical reduction CO2 to methane

Enhanced CO2 Reduction on a Cu-Decorated Single-Atom Catalyst via an Inverse Sandwich M-Graphene-Cu Structure

Highly Selective CO2-to-CO Electroreduction on Multisite Coordinated Single-Atom-modified Atomic Cluster Cu-based Catalyst

Electronic Structure Regulated Carbon-Based Single-Atom Catalysts for Highly Efficient and Stable Electrocatalysis.

S and N Coordinated Single-Atom Catalysts for Electrochemical CO2 Reduction with Superior Activity and Selectivity

Regulating the local electron density and adsorption energy of COF-based single copper sites for highly efficient Fenton-like photo-oxidation

Few-Atom Copper Catalyst for the Electrochemical Reduction of CO to Acetate: Synergetic Catalysis between Neighboring Cu Atoms

Tuning Carbon Defect in Copper Single‐Atom Catalysts for Efficient Oxygen Reduction

Liquid Fluxional Ga Single Atom Catalysts for Efficient Electrochemical CO2Reduction

Can Metal–Nitrogen–Carbon Single-Atom Catalysts Boost the Electroreduction of Carbon Monoxide?

Elucidating the Structure-Stability Relationship of Cu Single-Atom Catalysts Using Operando Surface-Enhanced Infrared Absorption Spectroscopy

Atomically Structural Regulations of Carbon‐Based Single‐Atom Catalysts for Electrochemical CO 2 Reduction

Modulating Electronic Structure Engineering of Atomically Dispersed Cobalt Catalyst in Fenton-like Reaction for Efficient Degradation of Organic Pollutants

Fabrication of Cu-Single Atom Catalyst Supported on Unique 2D Graphdiyne Analogue-Based Porphyrin Metal Covalent Organic Frameworks for Carbon Dioxide Reduction Application

The role of copper in enhancing the performance of heteronuclear diatomic catalysts for the electrochemical CO 2 conversion to C 1 chemicals