Abstract:The switching oscillations and voltage overshoots excited by ultrafast switching transients are urgently required to be overcome for SiC mosfet. Herein, the C-RC snubber is employed to address these adverse issues. An optimized C-RC snubber design is proposed, which can not only suppress the switching oscillation and overvoltage, but also effectively reduce the snubber loss compared with the dc-link RC snubber. This will be beneficial to the actual application of this snubber into the high-power and high-frequency field. For the turn-off overvoltage, the varying tendency of the overshoot with snubber parameters are analyzed according to the equivalent impedance network so that the parameter selection principle can be obtained preliminarily. Then, the C-RC snubber parametric region where both oscillations and overvoltages can be sufficiently suppressed is established using the root locus. Distinctive from the prior-art C-RC design to seek the peak impedance, the proposed switching ringing suppression method is developed by the way of actively assigning poles of fifth-order system to tune an optimal damping ratio. Then, the final design can be determined by minimizing the snubber loss within the obtained parametric range. Finally, the influence of snubber circuit on overvoltage, switching oscillation, and snubber loss are illustrated and verified in detail using the double-pulse tests. Moreover, the application of C-RC snubber in the chopper circuit further highlights its superiority of low snubber loss.

Design of RCD Snubber Considering Asymmetric Absorption Position of Multiple Switches in Parallel for LLC Application

Suppression Switching Oscillation in Three-Phase Inverter with 1.7kv/300a SiC Modules

A Synchronous Rectifier Control Scheme to Realize ZVS Considering the Secondary Parasitic Capacitance in LLC Resonant Converter

Study On The Protection Of Asymmetric Bridge Circuit For Switched Reluctance Motor

Wide Range Dual Switch Forward-Flyback Converter With Symmetrical Rcd Clamp

An LLC -DAB Bidirectional DCX Converter with Wide Load Range ZVS and Reduced Switch Count

Two-lower-switch PFC converter with active snubber

Implementing Symmetrical Structure in MOV-RCD Snubber-Based DC Solid-State Circuit Breakers

Suppression Switching Ringing of SiC-MOSFET Inverters with Combined Design of DC Bus Snubber and Gate Drive

Multi-Domain Modeling and Design Optimization of Synchronous Rectifiers for SiC-Based High- Load-Current LLC Converter

Optimal design for the damping resistor in RCD-R snubber to suppress common-mode noise

Analysis and design considerations for EMI and losses of RCD snubber in flyback converter

C-RC Snubber Optimization Design for Improving Switching Characteristics of SiC MOSFET

An Optimized Digital Synchronous Rectification Scheme Based on Time-Domain Model of Resonant CLLC Circuit

A Novel Optimized Snubber with Time-Varying Capacitor for Synchronous Rectification, Analysis and Implementation

Design Optimization of RC Snubber Circuit for A SiC Power Module

Research on Snubber Circuits for Power Electronic Switch in DC Current Breaking

Accurate Analysis and Design of the Circuit Parameters of LLC DC–DC Converter With Synchronous Rectification

Capacitor Voltage Ripple Reduction of A 4-Level Hybrid Clamped Converter Using Switching State Redundancy for Medium-Voltage Drive

Control and Modulation of a Single-Phase AC/DC Converter with Smooth Bidirectional Mode Switching and Symmetrical Decoupling Voltage Compensation