Abstract:A widely embraced approach to mitigate the dynamic degradation in low-inertia power systems is to mimic generation response using grid-connected inverters to restore the grid's stiffness. In this paper, we seek to challenge this approach and advocate for a principled design based on a systematic analysis of the performance trade-offs of inverter-based frequency control. With this aim, we perform a qualitative and quantitative study comparing the effect of conventional control strategies --droop control (DC) and virtual inertia (VI)-- on several performance metrics induced by $\mathcal L_2$ and $\mathcal L_\infty$ signal norms. By extending a recently proposed modal decomposition method, we capture the effect of step and stochastic power disturbances, and frequency measurement noise, on the overall transient and steady-state behavior of the system. Our analysis unveils several limitations of these solutions, such as the inability of DC to improve dynamic frequency response without increasing steady-state control effort, or the large frequency variance that VI introduces in the presence of measurement noise. We further propose a novel dynam-i-c Droop controller (iDroop) that overcomes the limitations of DC and VI. More precisely, we show that iDroop can be tuned to achieve high noise rejection, fast system-wide synchronization, or frequency overshoot (Nadir) elimination without affecting the steady-state control effort share, and propose a tuning recommendation that strikes a balance among these objectives. Extensive numerical experimentation shows that the proposed tuning is effective even when our proportionality assumptions are not valid, and that the particular tuning used for Nadir elimination strikes a good trade-off among various performance metrics.

Equivalent Inertia Provided by Droop Control of Fast Frequency Regulation Resources

Coordinated Control of Air-Conditioning Loads for System Frequency Regulation.

Dynamic Droop Control in Low-inertia Power Systems

Adaptive Inertia VSG Control Method Involving Power and Power Change Rate

Improvement of Frequency Regulation in AC Microgrid with Adaptive Virtual Inertia Droop Control

Variable Power Tracking Control Strategy of Doubly Fed Induction Generators for Fast Frequency Responses

Dynamic Droop Approach for Storage-based Frequency Control

Flexible Energy Converter Based on Adaptive Droop Control

Reactive Power-Voltage Droop Design of Dispatchable Virtual Oscillator Control for Single-Phase Inverters

Multi-Objective Adaptive Inertia and Droop Control Method of Wind Turbine Generators

A Dual-Adaptivity Inertia Control Strategy for Virtual Synchronous Generator

Nonlinear Droop Control of VSWTs for Sustained Frequency Regulation

Rotor Inertia Adaptive Control and Inertia Matching Strategy Based on Parallel Virtual Synchronous Generators System

A Frequency Response Strategy for Variable Speed Wind Turbine Based on a Dynamic Inertial Response and Tip-Speed Ratio Control

Improved Adaptive Inertia Control of VSG for Low Frequency Oscillation Suppression

An Inertial Droop Control Based on Comparisons Between Virtual Synchronous Generator and Droop Control in Inverter-Based Distributed Generators

Analysis of Inertia Mechanism of Grid-tied Photovoltaic Power Generation System with Virtual Inertia Control

Comparative Analysis and Improvement of Generalized Droop Control and Virtual Synchronous Generator for Rate of Change of Frequency Constraint and Transient Power Suppression

Equivalent Modeling of Inverter Air Conditioners for Providing Frequency Regulation Service

Voltage Imbalance Compensation for Doubly Fed Induction Generator Using Direct Resonant Feedback Regulator

Equivalent Inertial Time Constant of Doubly Fed Induction Generator Considering Synthetic Inertial Control