Zinc-based Activated Fe/Co/N Doped Biomass Carbon Electrocatalysts with High Oxygen Reduction Activity

Yujing He,Jiale Li,Dongyang Wang,Fuling Wang,Zuoxu Xiao,Yanli Chen
DOI: https://doi.org/10.7503/cjcu20220475
2022-01-01
Abstract:To promote the wide application of clean energy fuel cells, there is an urgent need to develop transition metal-based high-efficiency oxygen reduction (ORR) catalytic materials with low cost and a wide source of raw materials to replace the precious metal platinum-based catalytic materials currently in use. In this paper, non-noble metal ions such as iron and cobalt metal ions were used as the main active sites of catalytic materials, and the carbon source of sodium alginate, a marine biomass material with a three-dimensional pore structure, rich in carboxyl, hydroxyl groups, and easy to form in aqueous gel networks, was preanchored in situ by metal-carboxyl/ hydroxyl chelating key, freeze-drying get aerogel. Then, through high-temperature carbonization, a highly active and stable Co/Zn/Fe/N@bio-C-2 oxygen reduction catalyst material with active sites evenly distributed in the carbon skeleton with multistage pore structure was obtained. The catalyst consists of two different iron-based active materials (Fe2O3 and Fe) and two different cobalt-based active materials (CoO and Co). At the same time, zinc nitrate was used as an activator to improve the pore structure of the catalytic materials. The total area of the carbon materials increased from 149.3 m(2)/g to 325.3 m(2)/g. A series of comparative tests revealed that the synergistic effect of the Fe/Co dual active site and a suitable specific surface area resulted in the best ORR catalytic activity of Co/Zn/Fe/N@bio-C-2. The initial potential and half-wave potential reached 0.99 and 0.87 V in 0.1 mol/L KOH, respectively. This performance has reached the excellent level reported at present. This study provides a new strategy for the preparation of high-performance ORR catalyst materials by dispersing active sites and increasing the porosity of catalytic materials.
What problem does this paper attempt to address?