Abstract:In order to enhance the physical basis of the mass transfer model in numerical simulation of gas-liquid direct contact condensation and improve the fidelity, a set of methods and models are developed. Based on the concept of the piecewise-linear interface calculation (PLIC), an interface reconstruction algorithm is proposed to calculate the interfacial area concentration in three-dimensional non-orthogonal structured grids. The actual interface in the cell is replaced by a plane, whose position is determined iteratively to satisfy the local volume fraction and orientation of the actual interface. The area of the polygonal cut by the plane is taken as the interfacial area in the cell. The proposed algorithm is validated by calculating the surface area of a series of basic geometries. Obvious superiority of the proposed algorithm over the traditional models (gradient model and algebraic model) is seen. Then, the reconstructed area is used to determine the interfacial area concentration in the thermal phase change model. The process is implemented by ANSYS Fluent user-defined functions. The Stefan problem and steam bubble condensation experiment are used to test the performance of the developed methods and models. The simulation results agree well with the theoretical and experimental results with the quantitative relative errors no more than 4.3 % and 15 %, respectively. The oxygen jets condensation experiments are also used as test cases. The primary dominant frequencies predicted by the simulations are 163.01 Hz and 131.65 Hz, which agree well with the 139.72 Hz and 125.75 Hz in the experiments. The relative errors are only 17 % and 4.7 %. The unstable flow pattern of oxygen jet in liquid oxygen crossflow is explained based on the dynamic characteristics of turbulence, heat and mass transfer. The periodic variation of mass transfer rate is considered as the cause of condensation oscillation. The method for calculating the interfacial area proposed in this paper can serve as an optional and practical improvement to the numerical simulation of direct contact condensation.

Analysis of Vapor–Liquid Interfacial Transport Resistivities with DGT-PC-SAFT Based on the General Approach

A New General Correlation for the Influence Parameter in Density Gradient Theory and Peng–Robinson Equation of State for n-Alkanes

Theoretical Calculations of Interfacial Properties of High Carbon Alcohol-Hydrocarbon-ethanol-water Systems

Mixing Properties of Tris(2-ethylhexyl) Phosphate with Alkanes at Different Temperatures and Data Treatment Using Several Correlation Equations Based on Eyring's Absolute Reaction Theory

Enhancing the predictive capabilities for high P/T fuel sprays; non-ideal thermodynamic modelling using PC-SAFT

Simulations of Interfacial Tension of Liquid-Liquid Ternary Mixtures Using Optimized Parametrization for Coarse-Grained Models

Prediction of interfacial structure and tension of binary mixtures containing carbon dioxide

Calculation of Transport Parameters Using Ab Initio and AMOEBA Polarizable Force Field Methods

Simplified Gradient Theory Modeling of the Surface Tension for Binary Mixtures

Toward accurate density and interfacial tension modeling for carbon dioxide/water mixtures

Prediction of Diffusivities in Liquids

Prediction of vapor-liquid equilibrium and pvTx properties of mixtures containing HFOs, HFCs, HCs, and CO 2 using polar PC-SAFT model

Vapor‐liquid interfacial properties of binary mixtures from molecular simulation and density gradient theory

Surface tension calculation of HCs/HCs and HCs/CO 2 binary mixtures based on the gradient theory

Prediction of Vapor-Liquid Equilibrium and Pvtx Properties of Mixtures Containing HFOs, HFCs, HCs, and CO2 Using Polar PC-SAFT Model

pVT Data Analysis for the Prediction of Vapor Sorption in Glassy Polymers through the Nonequilibrium PC-SAFT Model

Two-Dimensional PC-SAFT-DFT Adsorption Models for Carbon Slit-Shaped Pores with Surface Energetical Heterogeneity and Geometrical Corrugation

Improving the Estimation Accuracy of Confined Vapor-Liquid Equilibria by Fine-tuning Pure Component Parameter in the PC-SAFT Equation of State

Development of a modified thermal phase change model based on the interfacial area concentration determined by an interface reconstruction algorithm

Development of 3D polymer DFT and its application to molecular transport through a surfactant-covered interface

Studies on Liquid–liquid Interfacial Tension with Standard Dissipative Particle Dynamics Method