Abstract:At ultralow shear rate (~0.01 s−1), acting below the yield stress of the aqueous gel, adsorption of calcium carbonate nanoparticles (<~100 nm) onto cellulose nanofibrils is induced without pigment–pigment preflocculation. Dispersant-free and polyacrylate treated dispersed carbonate particles are compared. Initially, it is seen that the polyacrylate dispersed material does not adsorb, whereas the dispersant-free carbonate adsorbs readily under the controlled ultralow shear conditions. However, repeated cycles of ultralow shear with intermittent periods in the rest state eventually induce the effect as initially seen with the dispersant-free calcium carbonate. The fibril suspension in the bulk is slightly acidic. The addition of buffer to a controlled pH in the case of the dispersant treated particles maintained a similar delay in the onset of adsorption, but adsorption occurred eventually after repeated cycles. During this cycling process, in parallel, the pH gradually drops under repeated cycles of ultralow shear, opposite to expectation, given the buffering capacity of calcium carbonate. The conductivity, in turn, progressively increases slightly at first and then significantly. The action of surface bound water on the nanofibril is considered key to the action of adsorption, and the condition of ultralow shear suggests that the residence time of the particle in contact with the nanofibril, acting under controlled strain against diffusion in the gel, is critical. It is proposed that under these specific conditions the calcium carbonate nanoparticles act as a probe of the nanofibril surface chemistry. The hydrogen bonded water, known to reside at the nanofibril surface, is thus considered the agent in the carbonate-surface interaction, effectively expressing an acid dissociation, and the calcium carbonate nanoparticles act as the probe to reveal it. An important phenomenon associated with this acid dissociation behaviour is that the adsorbed calcium carbonate particles subsequently act to flocculate the otherwise stable cellulose material, leading to release of water held in the aqueous gel matrix structure. This latter effect has major implications for the industrial ease of use of micro and nanofibrillar cellulose at increased solids content. This novel mechanism is also proposed for use to enhance the dewatering capability in general of complex cellulose-containing gel-like water-holding suspensions.

One-pot Preparation of Micro-Fibrillated Cellulose Fiber (MCF) Through the Synergistic Action of G-C3n4 and a Diluted Acid

A COMPARATIVE STUDY OF CELLULOSE NANOWHISKERS (cnws) AND CELLULOSE NANOFIBERS (Cnfs)

Preparation and Characterization of Nanofibrillated Cellulose from Bamboo Fiber Via Ultrasonication Assisted by Repulsive Effect

One-pot Conversion of Cellulose to HMF under Mild Conditions Through Decrystallization and Dehydration in Dimethyl Sulfoxide/tetraethylammonium Chloride

Micro- and nano-hybrid cellulose fibers prepared by straightforward and high-efficiency hot water soaking-assisted colloid grinding for high-performance cellulose paper

Fabrication of microfibrillated cellulose from biomass by use of carbon nitride with high nitrogen/carbon ratio

Preparation of microfibrillated cellulose by in situ and one step method using calcium hydroxide as swelling and grinding agent

Preparation of nanocellulose in high yield via chemi-mechanical synergy

High-yield and scalable cellulose nanomesh preparation via dilute acid vapor and enzymatic hydrolysis-mediated nanofabrication

A facile approach for preparing nanofibrillated cellulose from bleached corn stalk with tailored surface functions

Isolation of Cellulose Nanofibers (CNFs) based on Ball-milling Technique Combined with Supercritical Carbon dioxide/ethanol Pretreatment

One-pot Strategy to Enhance Nanofibrillation and Esterification of Cellulose Using Ternary Deep Eutectic Solvent

Reversible Surface Engineering of Cellulose Elementary Fibrils: From Ultralong Nanocelluloses to Advanced Cellulosic Materials

Preparation of Cellulose Nanocrystals by Synergistic Action of Ionic Liquid and Recyclable Solid Acid under Mild Conditions

Producing Cellulose Microfibrils at a High Solid Content with and without Mechanical or Enzymatic Pretreatment

Facile Preparation and Characteristic Analysis of Sulfated Cellulose Nanofibril via the Pretreatment of Sulfamic Acid-Glycerol Based Deep Eutectic Solvents

Efficient Cleavage of Strong Hydrogen Bonds in Sugarcane Bagasse by Ternary Acidic Deep Eutectic Solvent and Ultrasonication to Facile Fabrication of Cellulose Nanofibers

Facile Extraction of Cellulose Nanofibrils (Cnfs) from Wood Using Acidic Ionic Liquid-catalyzed Organosolv Pretreatment Followed by Ultrasonic Processing

Acid dissociation of surface bound water on cellulose nanofibrils in aqueous micro nanofibrillated cellulose (MNFC) gel revealed by adsorption of calcium carbonate nanoparticles under the application of ultralow shear

Highly efficient and green micro/nano cellulose preparation with micro-nano bubbles from mild alkali pretreated bagasse

A new facile and efficient strategy for high-yield preparation of spherical cellulose nanocrystals via enzymolysis-mechanical synergy