Abstract:Electrocardiography (ECG) is a primary tool for diagnosis of various types of disease and disorders such as arrhythmias, coronary heart disease, heart attack, mental disorders, etc. Reliable wearable ECG devices can be a valuable tool in early diagnosis and effective treatment of such disease and disorders. Convention wearable ECG sensor-systems are rigid, bulky, expensive, and the recorded ECG signals using these wearable devices lack required accuracy for medical diagnosis mainly due to motion artifacts that is originated from slippage of sensors on skin and/or instable interface between the soft sensor and the rigid electronic circuits. Here, we report a low-modulus, soft and stretchable wearable electrocardiography (ECG) sensor-system patch which enables continuous and long-term recording of ECG signals with minimal motion artifacts. This system consists of two reusable, detachable-attachable patches: sensor patch and circuit patch, as shown in Figure 1a. The reusable multi-wall carbon nanotube (MWCNT) based sensor patch is fabricated on stretchable elastomer substrate by our developed cost and time-effective method. Reusable, front-end and wireless circuit patch is made by integration of the off-the-shelf integrated circuit components with three-dimensional (3D) stretchable-deformable interconnects (SDI). SDIs are 3D springs of liquid metal (EGaIn). Unlike other reported liquid metal based interconnects, SDI has been designed in 3D form to increase the stretchability and make it low-modulus and robust to deformations in all directions. The stretchability of SDI structure is beyond 500% (the limit of our measurement system) without any negligible change in electrical resistivity of the interconnects. With less than 1% change in the resistance of SDIs after 50,000 cycles of applied tensile strain of 200%, the SDI structure ensures reliable stretchability and durability of the circuit patch for long-term electrocardiography. The sensor patch is soft, stretchable and it is fabricated using a low-cost scalable method. This soft and stretchable ECG sensor-system shows comparable performance with respect to medical grade Ag/AgCl wet gel electrodes. Our CNT-PDMS sensors shows low electrode-skin interface impedance and low susceptibility to motion artifact which similar of it in medical grade Ag/AgCl wet gel sensors (Fig. 1b). Further, it is waterproof, reusable and comfortable to wear. The circuit patch includes a rechargeable battery and ECG signals is wirelessly sent to a personal device such as cellphone, tablet and laptop through Bluetooth low energy (BLE) and it is displayed in real-time (Fig. 1c) Our developed sensor-system is a multi-use platform which can be applied for the detection of EMG, EEG or EOG signals. Figure 1

An Elastic and Damage-Tolerant Dry Epidermal Patch with Robust Skin Adhesion for Bioelectronic Interfacing

Congeneric and Robust Adhesive Epidermal Patch for Anti‐Interference Physiological Signal Recognition

Stretchable, Multifunctional Epidermal Sensor Patch for Surface Electromyography and Strain Measurements

3D printed multi-coupled bioinspired skin-electronic interfaces with enhanced adhesion for monitoring and treatment

Highly Stretchable and Skin Adhesive Soft Bioelectronic Patch for Long‐Term Ambulatory Electrocardiography Monitoring

A Stretchable, Breathable, And Self‐Adhesive Electronic Skin with Multimodal Sensing Capabilities for Human‐Centered Healthcare

Highly Adhesive and Stretchable Epidermal Electrode for Bimodal Recording Patch

Highly stretchable, sensitive and healable epidermal electronics enabled by dynamic hard domains and multidimensional conductive fillers for human motion and biopotential sensing

Motion‐Adaptive Tessellated Skin Patches With Switchable Adhesion for Wearable Electronics

(Digital Presentation) A Low-Modulus, Soft and Stretchable Wearable Electrocardiography Sensor-System Patch

Stretchable electronic skin patch with strain isolation for the simultaneous measurements of surface electromyography and temperature

Gas-permeable and stretchable on-skin electronics based on a gradient porous elastomer and self-assembled silver nanowires

Fully Nano/Micro-fibrous Triboelectric On-skin Patch with High Breathability and Hydrophobicity for Physiological Status Monitoring

A Breathable and Strain‐Insensitive Multi‐Layered E‐Skin Patch for Digital Healthcare Wearables

An On-Skin Electrode with Anti-Epidermal-Surface-Lipid Function Based on a Zwitterionic Polymer Brush.

Polymer Hydrogel Electronics with Adhesive, Self-Healing, and Anti-Ultraviolet Capabilities for Machine Learning-Promoted Electrophysiological Detection

Skin preparation–free, stretchable microneedle adhesive patches for reliable electrophysiological sensing and exoskeleton robot control

Functional-hydrogel-based electronic-skin patch for accelerated healing and monitoring of skin wounds

A Smart Patch with On‐Demand Detachable Adhesion for Bioelectronics

Ultrasoft, Adhesive And Millimeter Scale Epidermis Electronic Sensor For Real-Time Enduringly Monitoring Skin Strain

Stretchable, breathable, and washable epidermal electrodes based on microfoam reinforced ultrathin conductive nanocomposites