Abstract:The radial and axial vibration signals of a rotating machine are crucial information to understand the machine operation and to diagnose potential faults. Instead of using three single sensors to measure the horizontal, vertical and axial displacements of rotating shafts, a novel non-projection vision-based system was proposed to realize simultaneous measurement of the radial and axial displacements with high accuracy and good reliability using an tailored artificial constant density sinusoidal fringe pattern (CDSFP), which was pasted around the shaft surface and worked as a tri-axial (i.e. the horizontal, vertical and axial) displacement sensor. The measurement principle and setup of the proposed measurement system were well established. The horizontal displacement could be correctly obtained from the fringe period density changes of the CDSFP image sequence recorded by a high-speed camera. Simultaneously, the vertical displacement could be acquired by tracking the centerline of shaft whilst the axial displacement could be obtained by locating the peaks of the cross-correlation sequence of the fringe intensities. A sub-pixel method was employed to improve the displacement resolution of the developed system. The performance of the proposed system was demonstrated by the comparison of the experiments using eddy current sensors. It showed that the proposed method was an effective and accurate technique for real-time tri-axial vibration monitoring of rotating shaft. Experimental results verified the feasibility, effectiveness and good robustness of the proposed methodology, which demonstrated that the proposed system was capable of achieving accurate tri-axial vibration displacements of rotating shaft compared to the commercial eddy current sensor which could only measure one dimensional displacement at each measurement. Therefore, the vision-based tri-axial vibration monitoring system could be recommended for real engineering applications in condition monitoring of rotating shafts. (C) 2018 Elsevier Ltd. All rights reserved.

Panoramic amplitude-fluctuation electronic speckle pattern interferometry system for inner vibration measurement

Three-Dimensional Measurement System for Inner Surface of Long Tubular Parts Based on White Light Interference

Vibration Compensating Beam Scanning Interferometer for Surface Measurement

A High-Frequency Angular Vibration Calibration System Based on Phase Modulated Laser Interferometer Technique

A 360-Degree Panoramic Stereo Scanning Measurement System Based on a Panoramic Annular Lens and Omnidirectional Ring Structured Light

Vibration characteristics of pipe based on panoramic amplitude-fluctuation electronic speckle pattern interferometry

Sinusoidal Phase-Modulated Angle Interferometer for Angular Vibration Measurement.

Full-field vibration measurement based on binocular stereo vision and digital speckle image correlation

Research of Full-Field Deformation Measurement System

High/Low-Precision Digital Speckle Pattern Interferometry for Vibration Measurement

The System of Double-Optical-path ESPI for the Vibration Measurement

Optical Inertial Vibration Sensor System Using Grating Technology

A Vibration Compensation Method Based on White-light Wavelength Scanning Interferometry

Vibration measurement based on electronic speckle pattern interferometry and radial basis function

Real-Time One-Point Out-Of-Plane Displacement Measurement System Using Electronic Speckle Pattern Interferometry

Vibration Measurement Based on Speckle Projection and Digital Image Correlation Methods

Vibration Analysis Based on Electronic Stroboscopic Speckle--Shearing Pattern Interferometry

Acoustic-Excitation Optical Coherence Vibrometer for Real-Time Microstructure Vibration Measurement and Modal Analysis

Real-time Micro-vibration Measurement Based on Digital Holographic Interferometry

Real-time Three-Dimensional Vibration Monitoring of Rotating Shafts Using Constant-Density Sinusoidal Fringe Pattern As Tri-Axial Sensor

A Target-Free Vision-Based Method for Out-of-plane Vibration Measurement Using Projection Speckle and Camera Self-Calibration Technology