Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

A Ku-Band Low-Noise Amplifier in 40-nm CMOS

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A Highly Linear 2.4GHz Low Noise Amplifier

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

A Ku band low-voltage and low-power CMOS low-noise amplifier with bulk isolation techniques

A 20-GHz 4.8-dB NF low noise amplifier

A 28-nm E-band low noise amplifier with minimum 3.8 dB noise figure

A Ku-Band 3.3-V LNA with Multicoupled Q-Enhancement Transformer and Current-Reuse Techniques in 65-Nm CMOS

A K-Band High-Gain Lna In 0.13-Mu M Rf Cmos

A dual band CMOS two-stage variable gain low noise amplifier

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

A 3.4db NF K-Band LNA in 65nm CMOS Technology

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

A 23-30 GHz LNA with Noise-Cancelling in 28nm CMOS