Abstract:As one of the important parameters characterizing the cable's operation status, an accurate measurement of the current is particularly important for the cable's reliable operation and status monitoring. Aiming at the problem that the sum of the current phasors of multiphase cables is 0 when running in a steady state, and that the traditional mutual inductance current measurement method cannot be used for the phase current measurement of such cables, or that the insulation layer needs to be damaged, this paper proposes a non-contact measurement method of three-phase cable current, based on the magnetic field decoupling calculation. When combined with the actual parameters of the three-phase cable, the analytical calculation model of the magnetic field distribution of the three-phase cable is established. The relationship between the output ratio of the sensor and the deflection angle is obtained through theoretical derivation, the magnetic field coupling coefficient matrix is determined, and the transfer relationship between the output of the magnetic sensor and the current of each phase is clarified; an array magnetic field sensor is designed, which can sense the information of the adjacent magnetic field independently and is used for the reconstruction of three-phase currents. The effectiveness of the proposed method was tested on the built three-phase four-core cable current measurement test platform. The experimental results show that under the three-phase current balance, the measurement error of phase A, phase B and phase C is less than 2.8%, and the waveform and phase angle of the three-phase current can be well restored, which verifies the three-phase current measurement method proposed in this paper.

Adaptive positioning current measurement method for multi-conductor system based on linear magnetic sensor array

Contactless current measurement for suspended overhead lines using a magnetic field sensor array

Contactless Current Measurement for Enclosed Multiconductor Systems Based on Sensor Array.

The Application of Non-Invasive Sensor in Unbalanced Three-Phase Current Detecting

Event-Driven Non-Invasive Multi-Core Cable Current Monitoring Based on Sensor Array

Event-Based Non-Intrusive Home Current Measurement Using Sensor Array.

Intelligent Contactless Current Measurement for Overhead Transmission Lines

Parametric Reconstruction of Multiple Line Currents Based on Magnetic Sensor Array

Cooperative Rotor Position Estimation of Active Magnetic Bearings with Unsaturated Magnetic Bias

Electromagnetic field analysis and modeling of a relative position detection sensor for high speed maglev trains

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Study of Current Measurement Method Based on Circular Magnetic Field Sensing Array

Non-Contact Measurement Method of Phase Current Based on Magnetic Field Decoupling Calculation for Three-Phase Four-Core Cable

Adaptive Measurement for Automated Field Reconstruction and Calibration of Magnetic Systems

Sensorless Position Estimation for Permanent Magnet Synchronous Linear Motor with Variable Coupling Length

Planar 3-Degree-of-freedom Position Sensing Method Based on Decoupling Using a Linear-Hall Array

Noninvasive Current Sensor for Multicore Cables

A Novel Low-Cost Multicoil-Based Smart Current Sensor for Three-Phase Currents Sensing of Overhead Conductors

Measuring method for phase current of symmetrical three-core power cable based on magnetic sensors

Coil Positioning for Wireless Power Transfer System of Automatic Guided Vehicle Based on Magnetic Sensing

A New Current Measurement Method Based on Circular Tunneling Magnetoresistive Sensor Array