Abstract:This study investigates the correspondence between film cooling flow and convective heat transfer augmentation on the trailing edge cutback surface of a turbine blade, proposing a novel approach with oblong dimples in V-pattern pairs to enhance the cooling performance. Using transient infrared thermography coupled with the Impulse Response Method, detailed measurements of adiabatic film cooling effectiveness and heat transfer coefficients were obtained. Scale-Adaptive-Simulations (SAS) were also utilized to delve into the turbulent flow dynamics and elucidate the mechanisms behind the enhanced cooling performance. The experiments and simulations were conducted for a trailing edge model equipped with pin fin arrays inside the coolant channel and a land feature on the cutback surface. Overall, three different cutback surfaces were investigated: a smooth baseline geometry and two dimpled surfaces with different geometrical orientation. The cooling performance was evaluated over a range of blowing ratios spanning between 0.5 and 2. The results indicate that as the blowing ratio increases, there is a corresponding enhancement in both the adiabatic film cooling effectiveness and the heat transfer coefficients across all three cutback surface configurations. However, the dimpled patterns, when compared to the smooth one, showed a broader coolant film distribution and facilitated the formation of small-scale vortices, which in turn improved the heat transfer efficiency. Specifically, surfaces with a tighter arrangement of dimples exhibited superior cooling effects, achieving approximately 5.0 % increase in the film cooling effectiveness and an 8.9 % boost in the convective heat transfer coefficients. Moreover, the strategic placement of V-pattern dimples effectively steers the coolant flow close to the wall towards the land, significantly enhancing coolant spread and thus offering improved thermal protection for the land area. These findings hold the potential to significantly improve the performance of aero-engines by optimizing the trade-off between thermal management and aerodynamic efficiency of turbine blades.

LARGE EDDY SIMULATION STUDY ON THE APPLICATION OF A WHISKER STRUCTURE TO THE LIP OF A TRAILING EDGE CUTBACK

DDES Study on a Pressure-Side Cutback Cooling Turbine Blade with a Whisker Lip and a Whisker Trailing Edge

Experimental investigations on cooling characteristics of different trailing-edge cutback geometries

DDES Study on the Influence of a Whisker Trailing Edge on the Wake-Blade Interaction of a High-Pressure Turbine Stage

Effects of Blowing Ratios and Lip Thicknesses on Film Cooling for Trailing Edge Cutback with Latticework Ducts

Numerical Investigation on the Biomimetic Trailing Edge of a High-Subsonic Turbine Blade

Investigations into Film Cooling and Unsteady Flow Characteristics in a Blade Trailing-Edge Cutback Region

Film cooling enhancement over oblong-dimpled cutback surfaces for the trailing edge of turbine blades

Numerical Study on the Biomimetic Trailing Edge in the Environment of a High-Pressure Turbine Stage

Large Eddy Simulation Investigation of Micro-Vortex Generator Control Effect on Early Stage Sheet Cavitation

Investigation of Leading Edge Tubercles with Different Wavelengths in an Annular Compressor Cascade

Numerical Study on the Biomimetic Trailing Edge of a Turbine Blade under a Wide Range of Outlet Mach Numbers

Unsteady Investigations on Cooling Performance of a Gas Turbine Tailing Edge Cut-Back

Application of Humpback Whale Flippers in an Annular Compressor Cascade

Delayed-Detached Eddy Simulations of Film Cooling Effect on Trailing Edge Cutback with Land Extensions

Numerical Study On Film Cooling And Convective Heat Transfer Characteristics In The Cutback Region Of Turbine Blade Trailing Edge

DES study of the unsteady flow and film cooling at trailing edge cutback with various internal rib configurations

Cutback Squealer Tip Trailing Edge Cooling Performance

Investigation of backface cavity sealing flow in deeply scalloped radial turbines

Study of Secondary Cooling Effect on the Endwall Region with Various Trailing Edge Cutback Configurations

Experimental and unsteady numerical investigations on cooling characteristics of trailing-edge cutback with effect of upstream film holes