Abstract:One of the key issues to achieve the phase I mission of China fusion engineering test reactor (CFETR) is steady-state operation with a modest fusion power up to 200 MW. To study this feasibility, time-dependent modeling of CFETR baseline scenario is performed. The time-dependent scenario design examines actual discharge features, including auxiliary heating and current drive scheme, equilibrium, transport, PF coil systems and plasma control system during the plasma evolution. During plasma current ramp-up, 10 MW of EC or LH heating is used to effectively save volt-second consumption to a reasonable level within magnet coil capability and to reduce li for better plasma control. Three reference scenarios are designed to target full non-inductive operation with different external heating and current drive (H&CD), which are NB + EC, NB + LH, and LH + EC, respectively. Two scenarios with neutral beams reach the required fusion power of CFETR phase I target, while for LH + EC scenario the fusion power and confinement is somewhat lower. A reversed magnetic shear with q(min) > 2 is sustained with off-axis current drive and bootstrap current for all cases examined. Ideal MHD analysis shows that both large toroidal mode number n ballooning mode and low n kink mode are stable in the three reference cases independent of whether the current is totally relaxed or not. The L mode and H-L back transition ramp-down are designed to successfully reduce the plasma current to 2 MA and keep li below 2 with ramp-down rate of 80 kA s(-1). The H-L back transition ramp-down yields improvements in the power transfer and coil current evolution as well as the li evolution. The heating and current drive characteristics of three auxiliary heating sources are indicated by scanning studies. A 2D scan of NB energy and tangency radius indicates the features of NB power deposition, current drive, torque and shine through issue. Both ramp-up and flattop are considered in the scanning of radio frequency parameters. For EC waves, the ramp-up phase constrains the parameter space more. The 2D scan of EC launch angle shows that EC waves launched above the midplane yield a better CD efficiency than using a midplane launcher. Specifically, 10 MW of EC waves launched from LFS above the midplane yield a maximum on axis driven current of about 0.55 MA, while waves launched from top yield a maximum near edge driven current of about 0.45 MA in the region of rho > 0.5. Scanning of n(vertical bar vertical bar) in LH spectrum shows that n(vertical bar vertical bar) should be set around 1.7 to get enough penetration (inside rho = 0.7) for current drive and avoid strong accessibility problem. It is found that LH waves launched from HFS drives more current than that launched from LFS when n(vertical bar vertical bar) is small. 'the maximum LH driven current reaches 1.1 MA with 10 MW of LH power launched from HFS.

100 Kw Electron-Beam High Heat Flux Test Facility for Testing EAST and CFETR Divertor Components

Beam instrumentation system for shanghai soft x-ray fel test facility*

China’s Technological Achievements on ITER Enhanced Heat Flux First Wall in the Pre-Pa Qualification

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Physics Design of New Lower Tungsten Divertor for Long-Pulse High-Power Operations in EAST

Progress of Physics Understanding for Long Pulse High-Performance Plasmas on EAST Towards the Steady-State Operation of ITER and CFETR

EAST steady-state long pulse H-mode with core-edge integration for CFETR

Electron beam profile measurement using enhanced dual-techniques in high heat flux test facility at Institute for Plasma Research

Research on long pulse ECRH system of EAST in support of ITER

Advances in the Long-Pulse Steady-State High Beta H-mode Scenario with Active Controls of Divertor Heat and Particle Fluxes in EAST

Development of the high temperature PbLi experimental facility for CFETR

Integrated Operating Scenario to Achieve 100-Second, High Electron Temperature Discharge on East

Progress of High Power and Long Pulse ECRH System in EAST

Design Status of the ECRH System for CFETR

Estimation of Peak Heat Flux Onto the Targets for CFETR with Extended Divertor Leg

Integrated Operation of Steady-State Long-Pulse H-mode in Experimental Advanced Superconducting Tokamak

Integrated operation in achieving steady-state H-mode plasma on EAST

The Time-Dependent Simulation of CFETR Baseline Steady-State Scenarios

Advances in Physics Understanding of High Poloidal Beta Regime Toward Steady-State Operation of CFETR

Study of W/Cu Flat-Type Mock-Ups with Novel Hypervapotron Cooling Structure for CFETR Divertor

Design of a 200kev High Pulse Current Electron Beam Facility