Abstract:The plastic deformation behavior of metal plates has been proved to be affected by loading paths. Plastic flow is a critical component in the mechanical description of plastic deformation, like yield and hardening. In this work, the anisotropic plastic flow of two metal plates (16MnCr5 and S420MC) under non-proportional loading conditions was investigated. Large specimens manufactured along different orientations were pre-tensioned up to various strain levels; subsequently, small uniaxial tensile specimens were cut from the pre-tensioned specimens along different orientations with the interval of 15°, and then loaded to rupture. Meanwhile, the r-value, a measure of anisotropic plastic flow, was recorded. Result shows that for the studied plates which had constant r-value in the monotonic uniaxial tensile tests, a downward evolution of the r-value against plastic strain was observed when the Schmitt angle of two stage loading directions was greater than 90°. As the plastic strain in the subsequent loading stage accumulated, the r-value dropped from a higher level to its original level within a strain range about 6.0%. Based on the transient r-value evolution, a HEXAH-based evolutionary plastic potential model was constructed within the framework of non-associated flow (non-AF) theory. In the model, a local ellipse-shape distortion of the plastic potential surface was defined during plastic deformation process and when the Schmitt angel exceeded 90°, such distortion caused a downward evolution of the r-value in the subsequent deformation. The calibration result indicates that the model could reproduce the transient r-value response relevant to loading path change. The proposed evolutionary plastic potential model can be applied together with different anisotropic hardening models in the non-AF theory to give a detailed description of the plastic deformation behavior and hopefully provide a solution for the accurate simulation of the complex sheet metal forming process.

Numerical Investigations on Plastic Responses of Strain-Rate Sensitive Panels under the Lateral Impact

Numerical Study of CFRP-Bonded Pressure Pipes Subject to Impact Load

Large Deflection Resistance and Fracture of Panels Subjected to the Lateral Penetration

Experimental and numerical analysis of laterally impacted stiffened plates considering the effect of strain rate

Experimental and Numerical Investigation on the Response of Stiffened Panels Subjected to Lateral Impact Considering Material Failure Criteria

Finite Element Analysis of Stiffened Composite Panels Subjected by Low-Velocity Impact

Experimental and Numerical Investigations on Low-Velocity Impact Response of High Strength Steel/composite Hybrid Plate

An Efficient Numerical Method to Analyze Low‐velocity Impact Response of Carbon Fiber Reinforced Thermoplastic Laminates

A numerical study of a composite sandwich panel under oblique impact

The Dynamic Ultimate Strength of Stiffened Panels under Axial Impact Loading

Dynamic response and failure of CFRP Kagome lattice core sandwich panels subjected to low-velocity impact

Experiment study of dynamic buckling for stiffened panels under longitudinal impact

Impact response of steel-PU foam-steel-concrete-steel panel: Experimental, numerical and analytical studies

Study on characterization of moderate energy impact response of elastic-plastic plate structure

Experimental and Modeling Investigation on Anisotropic Plastic Flow of Metal Plates under Nonproportional Loading Conditions

The Dynamic Response and Failure of Polycarbonate Plate by Soft Body Impact

An Experimental and Numerical Study on Impact and Compression after Impact of Stiffened Composite Panels

Experimental and Numerical Studies on Steel-Polyurethane Foam-Steel–concrete-steel Panel under Impact Loading by a Hemispherical Head

Numerical and Theoretical Analysis of the Inertia Effects and Interfacial Friction in SHPB Test Systems

Dynamic buckling experiments for stiffened panels under falling hammer impact

Experimental and numerical simulation of dynamic response of U-type corrugated sandwich panels under low-velocity impact