Abstract:The use of recycled brick aggregates (RBAs) in concrete could provide sustainable solution in construction industry by reducing the consumption of natural resources and protecting the environment by saving landfill sites. However, the use of RBAs is uncommon due to limited available research studies investigating its mechanical and durability behavior, especially the freeze-thaw (FT) behavior. Despite a few studies on FT resistance of RBA concrete (RBAC), the FT deterioration mechanism in RBAC is not fully understood, particularly at the microscale. This lack of understanding hinders the widespread adoption of RBAC in sustainable construction practices, particularly in cold regions. Therefore, this study investigates the FT deterioration mechanism in RBAC using macro and microscale experiments and proposes a Weibull damage model to accurately describe the damage variation in RBAC. RBAC specimens with different water-cement (w/c) ratios of 0.65, 0.5 and 0.35 and RBA replacement levels of 0%, 25%, 50% and 100% were produced and tested under rapid FT cycles. Surface scaling, mass loss, relative dynamic modulus of elasticity, and compressive strength reduction were evaluated. X-ray computed tomography (XCT) was used to characterize pore structure and microcracking alterations during FT cycles. The results showed that the deterioration of RBAC increased with the increase in RBA replacement level. XCT revealed increased porosity and microcracking within the RBA particles, which was linked to the significant damage observed in RBAC compared to reference concrete. Quantitative analysis of pore size distribution before and after FT cycling revealed a substantial increase in small pores (<1 mm3) in RBAC. The proposed Weibull distribution damage model accurately described the damage variation in RBAC with different w/c ratios. This study provides new insights into multiscale FT deterioration mechanisms affecting RBAC, aiding in optimizing RBAC mix designs to balance sustainability and durability.

Impact of Overburnt Distorted Brick Aggregate on the Performance of Concrete at Ambient Temperature and after Exposure to Elevated Temperatures

Characterizations and Quantification of Freeze-Thaw Behaviors of Recycled Brick Aggregate Concrete

Experimental study on dynamic behavior of concrete at elevated temperatures

Influence of Elevated Temperatures on the Compressive Strength of Concrete Made with Different Types of Aggregate

Residual mechanical properties of recycled aggregate concrete at elevated temperatures

Experimental and Analytical Investigation of Crack Spacing and Width for Overlaid RC Beams at Elevated Temperatures

Effects of Elevated Temperature on the Residual Behavior of Concrete Containing Marble Dust and Foundry Sand

Performance of Different Concrete Types Exposed to Elevated Temperatures: A Review

High-temperature performance of ambient-cured alkali-activated binder concrete

Stress–strain characteristics of fire‐exposed recycled coarse aggregate concrete

Study on Shear Behavior of Concrete-polymer Cement Mortar at Elevated Temperature

Performance Degradation and Microscopic Analysis of Lightweight Aggregate Concrete after Exposure to High Temperature

Repeated Impact Response of Normal- and High-Strength Concrete Subjected to Temperatures up to 600 °C

Investigation on Concrete-Pcm Interface under Elevated Temperature: at Material Level and Member Level

Aggregate Type Influence on Microstructural Behavior of Concrete Exposed to Elevated Temperature

Crack-Spacing-Based Flexural Capacity of Polymer Cement Mortar-Overlay Reinforced Concrete Beams at High Environmental Temperature

Fresh and hardened properties of concrete made with recycled brick aggregate

Influence of temperature on mechanical properties of recycled asphalt pavement aggregate and recycled coarse aggregate concrete

Dynamic Tensile Properties and Energy Dissipation of High-Strength Concrete after Exposure to Elevated Temperatures

Effect of Elevated Temperatures on Compressive Strength of Concrete

Thermal and residual mechanical profile of recycled aggregate concrete prepared with carbonated concrete aggregates after exposure to elevated temperatures