Fluid phenomena of laser-induced Al plasma in ambient gas

张树东,张为俊
DOI: https://doi.org/10.3969/j.issn.1000-0364.2001.02.009
2001-01-01
Abstract:Q-switch Nd:YAG laser (wavelength 1.06 μm, pulse width l0 ns, energy 250 mJ/pulse) is used to ablate plane solid Al target in different ambient gas pressures. Using short focal length camera and optical-multichannel-analysis system(OMA), the fluid phenomena and spatial resolved emission spectra of laser-induced Al plasma have been recorded in Ar ambient gas. The experiment shows, when the background gas pressure is less than 400 Pa,a bright emission small sphere exists before the target surface, and the diameter of the sphere is much larger than the size of the laser-ablated point. The sphere irradiates to all direction, but there is a relative strong direction along the target surface vertical orientation. When the pressure is about 400 Pa, the plasma appears as a plume, and the solid degree of the plume becomes small When the pressure increased. As the pressure increases to 20~30 kPa, a emission sphere is separated from the frontier of the plume. By the pressure increases continually, the plume becomes to a series of emission spheres completely. The distance from target longer, the diameter of the spheres larger. Analyzing the components of the spectra of the emission spheres, the Al spectra and continuum spectra are the major near the target surface, but at the far area, there are only AlⅠ and ambient gases spectra. In particular,at 20 kPa pressure of Ar, the plasma plume became a color plume as the ablated point is shine and the plume frontier is green(514 nm ArⅡ)
What problem does this paper attempt to address?