Abstract:With the rapid development of high-power electronics, the thermal management of these emerging devices is challenging due to the danger of ultra high heat flux and uneven temperature distribution. In the past decade, certain heat-dissipation technologies based on micro-channel and micro-jet cooling have utilized geometrically identical heat sinks; however, their corresponding flow and thermal characteristics are quite dissimilar including temperature gradients, pressure drop and heat transfer coefficients only due to the different ways the coolant enters the test module. To characterize the enhanced heat-transfer mechanism driving this dissimilitude, a novel transition scheme between them was designed, featuring a gap on the channel fins top to provide extra flow area, and investigated experimentally and numerically. In this paper, by controlling the volumetric flow ratio of the channel and jet, including 1:1, 1:3 and 3:1, the flow and thermal characteristics of the transition scheme could be interchangeably transformed between the two schemes. Moreover, the effect of the vortex generated by the jet impingement was investigated, which was verified as an important factor causing the distinctions. The new results revealed that the vortex in the stagnation zone enhanced the local heat-transfer coefficient corresponding to the channel bottom and promoted temperature uniformity; however, it caused the thermal boundary layer on the fins top to thicken. Although the vortex was favorable for the forced convection in the acceleration zone, the vortex intersections formed by adjacent jets introduced a greater pressure-drop penalty and flow blockage, which were not conducive to enhancing the heat transfer. Subsequently, the Taguchi optimization method was employed to analyze effects of the aspect ratio, gap and jet diameters on flow and thermal characteristics. Accordingly, the optimal parameter combinations and contribution ratios were obtained. This paper systemat-ically shows how the micro-channel is transformed into a micro-jet cooling by adjusting the flow ratio and re-ports an intrinsic connection between them to promote a better understanding of cooling technologies used in electronic devices.

Experimental Study on the Boiling Heat Transfer Characteristics of a Pump-Driven Two-Phase Cooling Loop System for High Heat Flux Avionics

Study on the flow boiling characteristics of novel pin fin heat sinks in a two-phase mechanically pumped cooling loop

Design and Experimental Validation of a High Capacity Loop Heat Pipe for Avionics Cooling

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Experimental research on dynamic characteristics and control strategy of the pump-driven two-phase loop with dual evaporators

Experimental Study on the Heat Transfer Performance of Pump-assisted Capillary Phase-change Loop

Experimental investigation on mechanical pumped cooling loop for application in future space missions

Experimental study on an integrated system of thermosyphon loop and vapor compression assisted with phase change material for pulse heat load

Numerical Study on the Cooling Method of Phase Change Heat Exchange Unit with Layered Porous Media

Design and Performance Test of Miniature Capillary Pumped Loop for Electronics Cooling

Enhancing Boiling Heat Transfer by High-Frequency Pulsating Jet with Piezoelectric Micropump

Experimental Study on the Dynamic Heat Transfer Characteristics of a Mechanically Pumped Two-phase Cooling Loop

Flow and Thermal Analysis of the Transition Scheme Between Micro-Channel and Micro-Jet Cooling Solution

Experimental study of mechanical-capillary driven phase-change loop for heat dissipation of electronic devices and batteries

Experimental study on a rectangular evaporator loop heat pipe with a phase-change material heat sink

Experimental investigation on a mechanically pumped two-phase cooling loop with dual-evaporator

Thermal Modeling and Comparative Analysis of Jet Impingement Liquid Cooling for High Power Electronics

HEAT TRANSFER ENHANCEMENT OF A NEW SINGLE-PHASE HYBRID COOLING SCHEME OF MICROCHANNEL AND MICROJET IMPINGEMENT

Numerical Investigation on Thermal Performance of Two-Phase Immersion Cooling Method for High-Power Electronics

Effect of Direct Liquid Cooling Technology With Flow Guide Integration on Avionics Devices Thermal and Electrical Performance

An Immersed Jet Array Impingement Cooling Device with Distributed Returns for Direct Body Liquid Cooling of High Power Electronics