Abstract:Abstract Hydrodynamic slugging or two-phase liquid-gas flow instability in pipeline has caused loss in flow capacity and intense vibration at the separator leading to integrity issues. This issue can be resolve using foams generated from surfactants which are introduced into the pipeline to entrap and slow down gas flow, thus enhance its mixing with liquids. To understand how the behaviour or foams in a pipeline impact or alleviate slugging performances, the foams behaviour in the pipeline was simulated using OLGA. First, two main parameters i.e. foams viscosity and interfacial tension in the presence of crude oil were obtained from precision lab experiments. Using a foam rheometer, foam viscosity with crude oil was measured under actual pipeline conditions. Surfactant and crude oil were injected into the rheometer until 500 psi was reached. Then, gas was injected into the loop at a given foam quality (fg). Foam quality, or the gas-liquid ratio was sensitized to 40- and 50% (e.g. fg=40 is 40% gas volume of the total fluids). Shear rates of 100 to 1000 s-1 were applied, and foam viscosities were recorded. For interfacial tension test, the pendant drop method was used. A drop of aged emulsion was drop into a continuous phase of nitrogen gas. The interfacial tension values were assumed as gas-water (without and with surfactant) and gas-oil, at 90:10 water:crude oil cut as per field condition. In the model, first the baseline of the hydrodynamic slugging behaviour was established and simulated using actual pipeline dimension, gas and liquid flow rates, and actual fluids properties, which showed obvious liquid fluctuations. The simulation established at which viscosity and interfacial tension values would have an impact in alleviating slugging by interpreting the output QLT - total liquid volume flow (bbl/d). Foam viscosity for both fg=40 and 50 showed shear thinning behaviour i.e. as shear rate increases, viscosity falls as accordance to the power law. In the model, viscosity as low as 2.5 cP (at 1000 s-1, fg=40) showed reduction in liquid fluctuations as read from the QLT arriving at the inlet of the pipeline, compared to baseline without foam viscosity input. Liquid fluctuations were reduced by 97% just from viscosity change due to presence of foam. Interfacial tension input at 0.024 and 0.021 mN/m for gas-brine and gas-oil, respectively in the presence of surfactant was able to reduce the number of QLT spikes by 24%. By combining the inputs of both parameters, a reduction of QLT or liquid fluctuations by a total of 97% was recorded. This study showed that foams were able to slow down gas velocity and reduced liquid fluctuations thus reducing slugging in one of the problematic pipelines in Malaysia. Accurate foam viscosity measurements generated from the lab remains a vital input to the model - so as to understand behaviour of foam and quantify its impact before actual field applications.

Characteristics of Liquid Loading with Surfactant Injection in Hilly Terrain Pipeline

Influence of aqueous foam on gas–liquid flow development of hilly-terrain wet gas pipeline with surfactant injection

Effect of SDBS surfactant on gas-liquid flow pattern and pressure drop in upward-inclined pipelines

The Effect of Surfactants on the Initiation and Development of Air–water Slug Flow in Hilly Terrain Pipeline

Effect of SDS Surfactant on Gas-Liquid Flow and Slug Characteristics in Slightly Upward Pipeline

Effects of Foam on Slug Generation Mechanism in a Hilly Terrain Pipeline

Experimental and Numerical Investigation on Slug Initiation and Initial Development Behavior in Hilly-Terrain Pipeline at a Low Superficial Liquid Velocity

Experimental Investigation of the Surfactant Effect on Liquid Removal in Vertical Pipes

Experimental Study on Foam Drainage Technology for Removal of Liquid Accumulation in Pipelines with Undulating Profiles

Investigation of Slug Flow Characteristics in Hilly Terrain Pipeline Using Ultrasonic Doppler Method

Experimental and Numerical Study on Gas-Liquid Flow in Hilly-Terrain Pipeline-Riser Systems

Gas-Liquid Hydrodynamics during Liquid Displacement by Gas in Up-Hill Pipeline

Study of Non Intrusive Liquid Loading Detection Technology of Wet Gas Gathering Pipelines

Experiments and Predictions for Severe Slugging of Gas-Liquid Two-Phase Flows in a Long-Distance Pipeline-Riser System

STUDY OF LIQUID SLUG DEVELOPMENT CHARACTERISTIC IN HILLY TERRAIN PIPELINE UNDER MULTIPHASE SLUG FLOW

Experimental Study of Low Liquid Loading Gas-Liquid Flow in Near-Horizontal Pipes

Foams to Control Slugging Issues in Pipeline - From Lab to Simulation

Simulation Of Liquid-Gas Replacement In Commissioning Process For Large-Slope Crude Oil Pipeline

A foam drainage technology used in gathering pipelines under complex topographical conditions

Foam Stability: the Key to Inhibiting Slug Generation in Gas–liquid Flow

Influence of Surfactant on Two-Phase Flow Regime and Pressure Drop in Upward Inclined Pipes