Abstract:In this research, a high-efficiency design method of the capacitive MEMS accelerometer is proposed. As the MEMS accelerometer has high precision and a compact structure, much research has been carried out, which mainly focused on the structural design and materials selection. To overcome the inconvenience and inaccuracy of the traditional design method, an orthogonal design and the particle swarm optimization (PSO) algorithm are introduced to improve the design efficiency. The whole process includes a finite element method (FEM) simulation, high-efficiency design, and verification. Through the theoretical analysis, the working mechanism of capacitive MEMS accelerometer is clear. Based on the comparison among the sweep calculation results of these parameters in the FEM software, four representative structural parameters are selected for further study, and they are le, nf, lf and wPM, respectively. le and lf are the length of the sensing electrode and fixed electrode on the right. nf is the number of electrode pairs, and wPM is the width of the mass block. Then, in order to reduce computation, an orthogonal design is adopted and finally, 81 experimental groups are produced. Sensitivity SV and mass Ma are defined as evaluation parameters, and structural parameters of experimental groups are imported into the FEM software to obtain the corresponding calculation results. These simulation data are imported into neural networks with the PSO algorithm. For a comprehensively accurate examination, three cases are used to verify our design method, and every case endows the performance parameters with different weights and expected values. The corresponding structural parameters of each case are given out after 24 iterations. Finally, the maximum calculation errors of SV and Ma are 1.2941% and 0.1335%, respectively, proving the feasibility of the high-efficiency design method.

Theory and Application of an Optimal Design Method for Capacitive Six-Axis Force/torque Sensors

Design of Force-Balance Capacitive Accelerometer

Design and Optimization of Elastic Structure of Miniature Six-Dimensional Force/Torque Sensor

Design and optimization of a novel six-axis force/torque sensor with good isotropy and high sensitivity

Optimizations of structure stiffnesses and sensitivities of Y-type six-axis force/torque sensor

Optimum Design of a Dual-Range Force Sensor for Achieving High Sensitivity, Broad Bandwidth, and Large Measurement Range

Simulation-Driven Development and Optimization of a High-Performance Six-Dimensional Wrist Force/Torque Sensor

Design of Six-Axis Force Sensor and Analysis of Its Experimental Data

Research of Finite Element Simulation and Topology Optimization for Capacitive Angular Sensor

Design and Application of a New High-Performance Flexible Six-Axis Force/torque Sensor for Massage Therapy

Active Design Method for the Static Characteristics of a Piezoelectric Six-Axis Force/Torque Sensor

Structural Design and Static Calibration of Six-axis Force/Torque Sensor

Design and Calibration of a Novel Piezoelectric Six-Axis Force/torque Sensor

Active design method for the static characteristics of a piezoelectric six-axis force/torque sensor.

A Novel Parallel Piezoelectric Six-Axis Force/Torque Sensor and its Simulation

Design of a novel six-axis force/torque sensor based on strain gauges by finite element method

Stiffness analysis and parameter optimization of six-dimensional force sensor with the novel circular flexible spherical joint

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

Design and static calibration of a six-dimensional force/torque sensor for minimally invasive surgery

Design and analysis of parallel six-dimensional force sensor based on near-singular characteristics

Miniaturized Silicon-Based Capacitive Six-Axis Force/torque Sensor with Large Range, High Sensitivity, and Low Crosstalk