Abstract:A novel background calibration technique for Time-Interleaved Analog-to-Digital Converters (TI-ADCs) is presented in this paper. This technique is applicable to equalized digital communication receivers. As shown by Tsai et al. [1] and Luna et al. [2], in a digital receiver it is possible to treat the TI-ADC errors as part of the communication channel and take advantage of the adaptive equalizer to compensate them. Therefore calibration becomes an integral part of the channel equalization. No special purpose analog or digital calibration blocks or algorithms are required. However, there is a large class of receivers where the equalization technique cannot be directly applied because other signal processing blocks are located between the TI-ADC and the equalizer. The technique presented here generalizes earlier works to this class of receivers. The error backpropagation algorithm, traditionally used in machine learning, is applied to the error computed at the receiver slicer and used to adapt an auxiliary equalizer adjacent to the TI-ADC, called the Compensation Equalizer (CE). Simulations using a dual polarization optical coherent receiver model demonstrate accurate and robust mismatch compensation across different application scenarios. Several Quadrature Amplitude Modulation (QAM) schemes are tested in simulations and experimentally. Measurements on an emulation platform which includes an 8 bit, 4 GS/s TI-ADC prototype chip fabricated in 130nm CMOS technology, show an almost ideal mitigation of the impact of the mismatches on the receiver performance when 64-QAM and 256-QAM schemes are tested. An absolute improvement in the TI-ADC performance of $\sim$15 dB in both SNDR and SFDR is measured.

A Background Calibration for Joint Mismatch in the OFDM System with Time-Interleaved ADC

DC offset mismatch calibration for time-interleaved ADCs in high-speed OFDM receivers

FEC-Aided Decision Feedback Blind Mismatch Calibration of TIADCs in Wireless Time-Varying Channel Environments

Joint Background Calibration of Gain and Timing Mismatch Errors with Low Hardware Cost for Time-Interleaved ADCs

A Code-Pattern-driven Digital Background Calibration Technique for SAR ADCs

A Digital-Background TIADC Calibration Architecture and a Fast Calibration Algorithm for Timing-Error Mismatch

Calibration of Offset and Gain Mismatches in Time-Interleaved AD Converters

An Improved All-Digital Background Calibration Technique for Channel Mismatches in High Speed Time-Interleaved Analog-to-Digital Converters

Design and Experimental Verification of a Novel Error-Backpropagation-Based Background Calibration for Time Interleaved ADC in Digital Communication Receivers

Estiamtion and Correction of Mismatch Errors in Time-Interleaved Adcs

An improved wide-range, low-complexity, fully-parallel digital background timing mismatch calibration method for dual-channel TIADC based on perfect reconstruction filter bank

The fast time-interleaved ADC channel mismatch calibration method based on equivalent sampling and dynamic reference point

A Background Timing Skew Calibration Technique In Time-Interleaved Adcs

Calibration of Channel Mismatches in Time-interleaved ADCs Based on Multi-Frequency Reference Error Method

Spectrum distribution‐based blind calibration method of mismatches for time‐interleaved ADCs

TI-ADC multi-channel mismatch estimation and calibration in ultra-high-speed optical signal acquisition system

Machine-Learning Based Mismatch Calibration for Time-Interleaved ADCs

On the Application of Error Backpropagation to the Background Calibration of Time Interleaved ADC for Digital Communication Receivers

A Novel Multi-Channel Mismatch Estimation Method for Parallel Time-Interleaved System

A Wideband Timing Mismatch Calibration Design for Time-Interleaved Analog-to-Digital Converters with Fast Convergence

Lms-Fir Based Digital Background Calibration For The Four-Channel Time-Interleaved Adc