Investigation and Fabrication of the Printed Microstrip Meander-Line Slow-Wave Structures for D-Band Traveling Wave Tubes

Guo,Tianzhong Zhang,Jing Zeng,Zongyao Yang,Lingna Yue,Yanyu Wei

DOI: https://doi.org/10.1109/ted.2022.3192214

IF: 3.1

2022-01-01

IEEE Transactions on Electron Devices

Abstract:Two typical topology shapes of the microstrip meander line (MML) including round U-shaped and V-shaped slow-wave structure (SWS) for ${D}$ -band traveling wave tubes (TWTs) are comparatively investigated, fabricated, and tested in this article. As a critical factor applied in millimeter-wave frequency, the high-frequency losses of the MML SWS are emphatically discussed. The two types of golden SWSs are both fabricated with the thin-film circuit technology on quartz substrates. After the surface roughness test and the cavity fabrication, the SWS samples are assembled and tested. According to the experimental test results, the ${S}_{11}$ parameters of the U-shaped and V-shaped transmission models are below −13.5 dB versus −15 dB, and the “cold” ${S}_{21}$ parameters are over −6.4 dB versus −4.9 dB, which are approached to the simulation results with the consideration of the silver conductive paste (SCP). At 140 GHz, the tested transmission losses for the U-shaped SWS and V-shaped SWS are about 0.35 and 0.29 dB/mm, respectively. Although particle-in-cell (PIC) simulations for the two SWSs both predict more than 100-W output power, the V-shaped MML TWT shows better bandwidth and loss performances than the U-shaped MML TWT.