Broadband-Printed Traveling-Wave Tube Based on a Staggered Rings Microstrip Line Slow-Wave Structure
Ruichao Yang,Lingna Yue,Jin Xu,Pengcheng Yin,Jinjing Luo,Hexin Wang,Dongdong Jia,Jian Zhang,Hairong Yin,Jinchi Cai,Guo,Guoqing Zhao,Wenxiang Wang,Dazhi Li,Yanyu Wei
DOI: https://doi.org/10.3390/electronics11030384
IF: 2.9
2022-01-01
Electronics
Abstract:To increase the output power of microstrip line traveling-wave tubes, a staggered rings microstrip line (SRML) slow-wave structure (SWS) based on a U-shaped mender line (U-shaped ML) SWS and a ring-shaped microstrip line (RML) SWS has been proposed in this paper. Compared with U-shaped ML SWS and RML SWS, SRML SWS has a wider transverse width, which means SRML SWS has a larger area for beam–wave interaction. The simulation results show that SRML SWS has a wider bandwidth than U-shaped ML SWS and a lower phase velocity than RML SWS. Input/output couplers, which consist of microstrip probes and transition sections, have been designed to transmit signals from a rectangular waveguide to the SWS; the simulation results present that the designed input/output structure has good transmission characteristics. Particle-in-cell (PIC) simulation results indicate that the SRML TWT has a maximum output of 322 W at 32.5 GHz under a beam voltage of 9.7 kV and a beam current of 380 mA, and the corresponding electronic efficiency is around 8.74%. The output power is over 100 W in the frequency range of 27 GHz to 38 GHz.