A Novel Two-Stage Friction Stir-Assisted Incremental Sheet Forming Method for Uniform Microstructure and Enhanced Properties in Aluminum Alloys

Xuepeng Zhan,Dayong An,Jun Chen
DOI: https://doi.org/10.1016/j.ijmachtools.2022.103928
2022-01-01
Abstract:Usual single-pass friction stir-assisted incremental sheet forming (FS-ISF) can improve the formability of lowductility metallic sheets such as AA2024 and partially produce equiaxed grains by dynamic recrystallization on the components. However, the non-uniformity of the microstructure along the thickness direction degrades the formability and component properties. To solve this problem, a novel two-stage FS-ISF method is proposed by combining intermediate pass through an optimal compensation strategy with a reverse pass. A two-stage analytical model of FS-ISF is developed to minimize the grain gradient along the thickness direction and combined with the calibrated recrystallization model to implement the two-stage FS-ISF method. Using this method, uniform grains can be obtained along the thickness direction for AA2024-T3 sheet. Grain uniformity contributes to the increasing of material ductility by allowing concordant slip deformation under consistent motions of boundaries and grains with deep and coalesced dimples. The homogeneous fine precipitates within the grains, pinning effects, and more grain boundaries are induced by the two-stage FS-ISF method, which increases the strength of the formed part. Compared with usual single-pass FS-ISF, both the ultimate tensile strength and ductility are improved for AA2024-T3 using the two-stage FS-ISF method, which are also demonstrated for AA6061-T4 sheet. The two-stage FS-ISF method has the advantage of increasing the component strengths of different aluminum alloy sheets compared with artificial aging treatment after conventional incremental sheet forming or usual single-pass FS-ISF for different aluminum alloy sheets. The multi-pass FS-ISF method with reverse pass was validated through the fabrication of vertical-wall square cup with uniform thickness. The proposed method provides an efficient alternative to increase the strength and ductility during flexibly making the sheet metal panel of low-ductility material with challenging geometry.
What problem does this paper attempt to address?