Abstract:A micromixer is one of the most significant components in a microfluidic system. A three-dimensional micromixer was developed with advantages of high efficiency, simple fabrication, easy integration, and ease of mass production. The designed principle is based on the concepts of splitting–recombination and chaotic advection. A numerical model of this micromixer was established to characterize the mixing performance for different parameters. A critical Reynolds number (Re) was obtained from the simulation results. When the Re number is smaller than the critical value, the fluid mixing is mainly dependent on the mechanism of splitting–recombination, therefore, the length of the channel capable of complete mixing (complete mixing length) increases as the Re number increases. When the Re number is larger than the critical value, the fluid mixing is dominated by chaotic advection, and the complete mixing length decreases as the Re number increases. For normal fluids, a complete mixing length of 500 µm can be achieved at a very small Re number of 0.007 and increases to 2400 µm as the Re number increases to the critical value of 4.7. As the Re number keep increasing and passes the critical Re number, the complete mixing length continues to descend to 650 µm at the Re number of 66.7. For hard-to-mix fluids (generally referring to fluids with high viscosity and low diffusion coefficient, which are difficult to mix), even though no evidence of strong chaotic advection is presented in the simulation, the micromixer can still achieve a complete mixing length of 2550 µm. The mixing performance of the micromixer was also verified by experiments. The experimental results showed a consistent trend with the numerical simulation results, which both climb upward when the Re number is around 0.007 (flow rate of 0.03 μm/min) to around 10 (flow rate of 50 μm/min), then descend when the Re number is around 13.3 (flow rate of 60 µm/min).

A Low-Cost and High-Performance 3D Micromixer over a Wide Working Range and Its Application for High-Sensitivity Biomarker Detection

A Novel Passive Micromixer with Modified Asymmetric Lateral Wall Structures

Performance Evaluation and Scale-Up Behavior of an Engineered In-Line Mixer for 3D Printing

A Directly Moldable, Highly Compact, and Easy-for-Integration 3D Micromixer with Extraordinary Mixing Performance

Gradient Printing Alginate Herero Gel Microspheres for Three-Dimensional Cell Culture

A compact and efficient three-dimensional microfluidic mixer

Enhanced Mixing Efficiency for a Novel 3D Tesla Micromixer for Newtonian and Non-Newtonian Fluids

An Enhanced Electroosmotic Micromixer with an Efficient Asymmetric Lateral Structure.

An Efficient 3D-Printed Gravity Mixer for Lab-on-a-CD Applications

A Versatile Integrated Microfluidic Chip Based on Sonic Toothbrush-Assisted Mixing for Analyses of Diverse Biomolecules

Innovative 3D Microfluidic Tools for On-Chip Fluids and Particles Manipulation: From Design to Experimental Validation

Rapid method for design and fabrication of passive micromixers in microfluidic devices using a direct-printing process.

Design and development of an efficient fluid mixing for 3D printed lab-on-a-chip

Micromixing within microfluidic devices: Fundamentals, design, and fabrication

3-D microarray and its microfabrication-free fluidic immunoassay device

A Three-Dimensional Micromixer Using Oblique Embedded Ridges

Efficient Mixing of Microfluidic Chip with a Three-Dimensional Spiral Structure

3D printing cross‐scale mold for manufacturing micromixers

Experimental fluid dynamics characterization of a novel micropump-mixer

Numerical study of a novel electroosmotic active micromixer with twin diamond-shaped chambers and sawteeth

Fabrication of Patterned Magnetic Particles in Microchannels and Their Application in Micromixers