Abstract:The rotary compressors are currently witnessing a trend towards high-speed operation, resulting in an increased frequency of valve motion and a higher mass flow rate through the discharge valve. Consequently, high-speed operation leads to intensified impact between the valve and both the valve stopper and valve seat, thereby posing challenges to the reliability of the valve. Simultaneously, the dynamic characteristics of the valve at high operating speeds exert a significant influence on the compressor's performance. This paper develops a threedimensional fluid-structure interaction (FSI) model to investigate the dynamic characteristics and reliability of the valve in a high-speed rotary compressor while considering heat transfer during the flow process within the cylinder. The proposed model shows better agreement with the experiment. The study revealed that as the rotational speed increases, there is an obvious rise in over-compression loss and a pronounced valve closure delay, which increases the impact velocity of the valve. The valve experiences two peaks of equivalent stress within one cycle, rendering it susceptible to fail at high speeds. The adoption of a double-valve structure at a rotational speed of 12,000 rpm leads to a significant reduction in over-compression loss by 62.9 %, an increase in volumetric efficiency by 6.7 %, a maximum decrease in impact velocity by 54.5 %, and a maximum decrease in equivalent stress by 25.6 %. The reliability of the double-valve structure under 12,000 rpm was proved by an endurance experiment. Besides, the asymmetry in the opening process of the two valves has been unveiled for the first time.

Investigation of Dynamic Characteristics and Power Consumption of the Swing Compressor with No Valves

Simulation and Experimental Investigation on Pressure Dynamics of Pneumatic High-Speed On/off Valves

Numerical Investigation on Indicated Power and Discharge Process of Three Different Discharge Methods of Swing Compressor

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

Dynamic Characteristics of a Swing Compressor for an Air Conditioning System at Different Discharge Pressures

Theoretical Study on Frictional Losses of A Novel Automotive Swing Vane Compressor

Modeling and Analysis of the Churning Losses Characteristics of Swash Plate Axial Piston Pump

Dynamic Characteristics Modelling and Analysis for Dry Screw Vacuum Pumps

Analysis of the Thermodynamic Characteristics of a Hyper-Compressor through Numerical Simulation and Experimental Investigation

Friction Characteristics of Sliding Vane for Synchronal Rotary Compressor

Investigation of Discharge Valve in Ultra-High-speed Rotary Compressors: an Experimental and FSI Simulation-Based Study

Dynamic modeling and characteristics analysis of sliding vane in a high-speed rotary compressor considering groove distribution and multi-body coupling

Dynamic Characteristic of Rotary Vane Compressor

A Dynamic Model for Pin Coupling Anti-Rotation Mechanism of Automotive Scroll Compressor

Dynamic behavior analysis of a moving coil oil-free linear compressor in refrigeration system

Research on the Dynamic Characteristic of CO2 Scroll Compressor

Investigation of Flow Behaviour and Heat Rejection for an Air-Cooled Small Multi-Stage Swash-Plate Compressor

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation

Analysis of dynamic characteristic of scroll compressor

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Theoretical study and experimental verification of the leakage losses of R410A in the swing compressor with no valves