Abstract:The cement industry is one of the primary sources producing anthropogenic CO2 emissions. The significant increase in the demand for cement in years has significantly contributed to the increase in carbon emissions. Among numerous CO2 treatment technologies, calcium looping (CaL) is a practical approach to mitigating CO2 emissions. This paper used calcium looping (CaL) to capture CO2 from flue gas in a cement pre-calciner kiln system. The raw material exiting the lowest stage of the preheater is used as a calcium-based adsorbent, and the carbonation reactor is built between the tertiary and secondary preheaters, using the high-temperature flue gas exiting the tertiary preheater to provide heat for the reaction. The CFD (Computational Fluid Dynamics) simulation technology was used to evaluate the rationality of the carbonation reactor and the key factors affecting the carbon removal efficiency of the carbonation reactor. The results indicate that the velocity and pressure fields of the carbonation reactor conform to the general operating rules and are reasonable. The optimal operating speed of particles in the carbonation reactor is 15 m/s, with a separation efficiency of particles of 92.5%, ensuring the smooth discharge of reaction products. The factor analysis of the carbonation reactor shows that when the temperature is 911 K, the mass flow rate of CaO is 2.07 kg/s, and the volume fraction of CO2 is 0.28, the carbonation reaction reaches a chemical equilibrium state, and the carbon removal efficiency is 90%. It should be noted that this carbon removal efficiency is the optimal carbon removal efficiency based on a combination of economic factors. In addition, the influencing factors show a precise sequence: CO2 volume fraction > CaO addition amount > temperature. Finally, we investigated the impact of the addition of the carbonation reactor on the preheater system. The results show that adding the carbonation reactor causes an increase in the flue gas velocity at the outlet of the preheater and a decrease in pressure, reducing the separation efficiency. Although the separation efficiency decreases slightly, the impact on the pre-calciner system is minimal.

CFD-aided Optimization of the Decomposition Kinetics of Cement Raw Meals under High CO2 Concentrations

CFD-aided optimization of the decomposition kinetics of cement raw meals under high CO 2 concentrations

Advances in calcium carbonate thermal decomposition

Numerical simulation of O2/CO2 combustion in decomposition furnace

Numerical Simulation of CO2 Extraction from the Cement Pre-Calciner Kiln System

Numerical Study on Oxy-Biomass Co-Firing in a Cement Rotary Kiln

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

Experimental study and CFD modeling of NOx reduction and reductive gas formation in deep reburning of cement precalciner

Numerical simulation of oxygen-enriched combustion in a precalciner using coal gangue-blended pulverized fuel

The Co-Processing Combustion Characteristics of Municipal Sludge within an Industrial Cement Decomposition Furnace via Computational Fluid Dynamics

Improving Pulverized Coal and Biomass Co‐Combustion in a Cement Rotary Kiln by Computational Fluid Dynamics

Evaluation of carbonation conversion of recycled concrete fines using high-temperature CO 2 : Reaction kinetics and statistical method for parameters optimization

Coupled Oxygen-Enriched Combustion in Cement Industry CO2 Capture System: Process Modeling and Exergy Analysis

Optimization of methane catalytic decomposition in a fluidized bed reactor: A computational approach

Chemical Engineering Solution for Carbon Neutrality in Cement Industry: Tailor a Pathway from Inevitable Co2 Emission into Syngas

Optimization of Fuel In-Situ Reduction (FISR) Denitrification Technology for Cement Kiln using CFD Method

Optimization of Cyclone-Type Rotary Kiln Reactor for Carbonation of BOF Slag

Study on Optimal Setting of Decomposing Furnace Temperature Based on Soft Measurement

Optimization Control of Thermal Efficiency for Cement Raw Meal Pre-Decomposition Based on Two-Layer Structure Model Predictive Control

The Kinetic Mechanism of the Thermal Decomposition Reaction of Small Particles of Limestone at Steelmaking Temperatures