Abstract:The production of thermoplastic pellets using underwater die-face pelletizers is a widespread process in the thermoplastics compounding industry. One major challenge in this process is pellet agglomeration, which occurs when the polymer is pliable or easily deformed under heat. To tackle this issue, the non-Newtonian flow of a polymer, along with the turbulent flow of heating oil and heat transfer through the die, are modeled using three-dimensional (3D) computational fluid dynamics (CFD) calculations in ANSYS Fluent. The computational model is validated by comparing its predictions of temperature and pressure using two models with and without a slip method, to experimental measurements from an industrial-scale pelletizer, resulting in a maximum error of <3 % for temperature and <16 % for pressure. The efficiency of the underwater die pelletizer is typically evaluated based on the rate at which it produces pellets. Minor variations in operational parameters, such as the inlet mass flow rate and temperature of the polymer, the temperature of the heating oil, and the water temperature, can greatly affect the quality of the final product. Firstly, contours of pressure, velocity and temperature are presented to understand their impact on pellet agglomeration. However, to more specifically link pellet quality, i.e. pellet agglomeration rate, to the input conditions, the study develops a non-dimensional parameter called the pellet agglomeration number (PAN), as a non-linear function of three other non-dimensional numbers: Reynolds number, Euler number, and a non-dimensional temperature. The values of PAN at the exit and inlet are shown to correlate well with the experimentally measured pellet agglomerations, thereby demonstrating the usefulness of PAN in not only differentiating between good and bad pellet quality but also determining apriori the appropriate operating conditions leading to fewer pellet agglomerations in commercial pelletizers.

Numerical simulation on gas behavior inside pellet based on X-ray micro-computed tomography

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Numerical Simulation Of Gas-Flow In Ball Mill

CFD Simulation of the Steam Gasification of Millimeter-Sized Char Particle Using Thermally Thick Treatment

Numerical simulation of gasification characteristics in a circulating fluidized bed biomass gasifiers

3D numerical simulation of Texaco gasifier using assumed PDF model

3D numerical modeling of gas atomization process for powder preparation based on similarity theory

Numerical and Experimental Studies on the Improvement of Gas Chamber Structure During Gas-Assisted Extrusion

Numerical Simulation of Gas-particle Hydrodynamics in CFB

Numerical Simulation and Analysis of Effect of Injection Volume on Biomass Particle Cyclone Venturi Dryer

Three-dimensional Numerical Simulation of Entrained-Flow Gasifier and Influence of Coal Distribution at the Inlet

A Method for 3d Simulation of Internal Gas Effects on Thermal-Mechanical Behaviors in Nuclear Fuel Elements

Numerical investigation of gas thermal property in the gasification process of a spouted bed gasifier

The effect of pellet shape on turbulent hydrodynamics in narrow packed beds: A magnetic resonance velocity imaging study

Analyzing pellet agglomeration in underwater polymer extrusion pelletizers: a numerical simulation study

Numerical Simulation of Gas Quenching Process of Workpiece

Comparative analysis of flow factors and crystallinity in conventional extrusion and gas-assisted extrusion

Numerical investigation of transient gas–solid heat transfer in a packed bed: Impact of intra-particle thermal diffusion