Abstract:<p>In light of stricter emissions regulations and depleting fossil fuel reserves, fuel cell vehicles (FCVs) are one of the leading alternatives for powering future vehicles. An open‐cathode, air‐cooled proton exchange membrane fuel cell (PEMFC) stack provides a relatively simple electric generation system for a vehicle in terms of system complexity and number of components. The temperature within a PEMFC stack is critical to its level of performance and the electrochemical efficiency. Previously created computational models to study and predict the stack temperature have been limited in their scale and the inaccurate assumption that temperature is uniform throughout. The present work details the creation of a numerical model to study the temperature distribution of an 80‐cell Ballard 1020ACS stack by simulating the cooling airflow across the stack. Using computational fluid dynamics, a steady‐state airflow simulation was performed using experimental data to form boundary conditions where possible. Additionally, a parametric study was performed to investigate the effect of the distance between the stack and cooling fan on stack performance. Model validation was performed against published results. The temperature distribution across the stack was identical for the central 70% of the cells, with eccentric temperatures observed at the stack extremities, while the difference between coolant and bipolar plate temperatures was approximately 10°C at the cooling channel outlets. The results of the parametric study showed that the fan‐stack distance has a negligible effect on stack performance. The assumptions regarding stack temperature uniformity and measurement were challenged. Lastly, the hypothesis regarding the negligible effect of fan‐stack distance on stack performance was confirmed.</p>

Influence of Hydrogen Fuel Cell Temperature Safety on Bus Driving Characteristics and Stack Heating Mode

Modelling and Simulation of A Portable Fuel Cell System

Design and Application of a Thermal Characteristic Test Platform for Hydrogen Fuel Cells

Model-based temperature regulation of a PEM fuel cell system on a city bus

Analysis of Cooling and Heating Characteristics of Thermal Management System for Fuel Cell Bus

Thermal Management System Modeling and Simulation of a Full-Powered Fuel Cell Vehicle

Modeling and simulation of vehicle integrated thermal management system for a fuel cell hybrid vehicle

Experimental and Numerical Research on Temperature Evolution during the Fast-Filling Process of a Type III Hydrogen Tank

Thermal characteristics of an air‐cooled open‐cathode proton exchange membrane fuel cell stack via numerical investigation

Numerical Analysis of Temperature Rise Within 70 MPa Composite Hydrogen Vehicle Cylinder During Fast Refueling

Sensitivity analysis of operating parameters on a 65 kW proton exchange membrane fuel cell stack performances

System Modeling and Temperature Control for a Fuel Cell System Based on Local Model Networks

Improvement of Temperature and Humidity Control of Proton Exchange Membrane Fuel Cells

A single-phase, non-isothermal model for PEM fuel cells

Thermal Management Subsystem Model and Temperature Control for Fuel Cells

Comparison of Different Topologies of Thermal Management Subsystems in Multi-Stack Fuel Cell Systems

Temperature Model and Predictive Control for Fuel Cells in Switcher Locomotive

Numerical Simulation on Pressure Dynamic Response Characteristics of Hydrogen Systems for Fuel Cell Vehicles

Study on the Heat and Mass Transfer Mechanisms of Liquid-Cooled PEMFC Stacks Based on Non-Isothermal Model

Theoretical and Experimental Study of a Fuel Cell Stack Based on Perfluoro-sulfonic Acid Membranes Facing High Temperature Application Environments

Model-Based Temperature Tracking Control in Automotive Fuel Cells