Abstract:This paper introduces a compact picosecond laser system using tapered double cladding fiber-single crystal fiber hybrid amplification technology for the first time. By modifying the Ginzburg-Landau equation, we established a simulation model and designed a passive mode-locked picosecond oscillator based on a semiconductor saturable absorber mirror. The oscillator outputs laser with a pulse width of 7.75 ps, a center wavelength of 1030.55 nm, and a spectrum width of 0.58 nm. The seed laser is stretched and amplified by the all-fiber front stage, and then injected into the tapered double cladding fiber-single crystal fiber hybrid amplifier. The laser power is amplified from 820 mw to 103.1 W, obtaining a gain of 21 dB. We used zero-phonon line pumping technology in single crystal fiber amplifier to reduce the thermal effects caused by quantum loss, thereby increasing the length of the crystal and increasing the power loading capacity. We designed a single crystal fiber amplification module using Yb:YAG with 60 mm long, 1 mm diameter and a 1 at.% doping rate for the first time. Finally a hundred-watt level picosecond laser output with a repetition frequency of 26.33 MHz, an average power of 103.1 W, a pulse width of 244.72 ps, a spectrum width of 1.16 nm, and a beam quality of M2 x = 1.368 and M2 y = 1.511 was obtained. To the best of our knowledge, this is the highest picosecond laser output power for an all-fiber front-stage combined with a single-stage single crystal fiber amplifier.

High Stability Hundreds of Picoseconds Pulse Compression Using Self-Pumped SBS

Study on Stimulated Brillouin Scattering Pulse Waveform

High stability, single frequency, 300 mJ, 130 ps laser pulse generation based on stimulated Brillouin scattering pulse compression

1.35Ns SBS Laser Pulse

Pulse Duration Compression by Two-Stage Stimulated Brillouin Scattering and Stimulated Raman Scattering

SBS pulse compression using bulk fused silica by diode-pumped solid-state lasers at 1 kHz repetition rate

Combined Compression of Stimulated Brillouin Scattering and Laser–Induced Breakdown Enhanced with Sic Nanowire

Nanosecond-pulse High-Peak-power Circle-Focusing Laser Beam for Laser Processing

Sub-350 fs Pulse Generation via Nonlinear Compression With an Nd-Doped Picosecond Laser

Robust Q-switching based on stimulated Brillouin scattering assisted by Fabry-Perot interference.

Compact hundred-watt level picosecond laser system based on tapered double cladding fiber-single crystal fiber hybrid amplifier

Self-compression of ultrahigh-peak-power lasers

All-Solid-State Post-Compression of Low-Energy Pulses at High Repetition Rate

Characterization of sub-nanosecond pulse compression based on frequency-detuning SBS

180 Mj, Long-Pulse-duration, Master-Oscillator Power Amplifier with Linewidth Less Than 256 Khz for Laser Guide Stars

293 W, GHz narrow-linewidth, polarization maintaining nanosecond fiber amplifier with SBS suppression employing simultaneous phase and intensity modulation

Structure of 5-hydroxy-2-hydroxymethyl-1-methylpyrid-4-one and 13C NMR relaxation studies of its gadolinium(III) complex.

Brillouin light storage for 100 pulse widths

Compressed 6 ps pulse in nonlinear amplification of a Q-switched microchip laser

Stabilized Brillouin laser with sub-Hz fundamental linewidth aided by frequency shifted optical injection locking

Nearly Self-Similar Pulse Compression in Horizontally Slotted Waveguides at 2.0 μm