Tribological Behavior of Extruded Spray-Forming 2195-T6 Al-Li Alloy at Different Loads Using Pin-on-disk Tribotester

Qingqiang Chen,Yalei Yu,Guanjie Ma,Zhonglei Wang,Jie Sun,Laixiao Lu
DOI: https://doi.org/10.1088/2053-1591/ac803c
IF: 2.025
2022-01-01
Materials Research Express
Abstract:The tribological properties of Al-Li alloys impact the reliability of components used in different industrial sectors. In this research, the effect of normal load on friction and wear properties of the extruded spray-formed 2195-T6 Al-Li alloy is investigated by using a pin-on-disk tester. Through the microstructure of the friction subsurface, it is evaluated that the friction coefficient of 2195 alloy decreases from 0.408 to 0.306 by increasing load (25 N to 150 N), while the wear rate increases exponentially. It is also analyzed that a mild-severe wear transition occurs between 100 N and 125 N and the main wear mechanism gradually shifts from abrasive wear and oxidative wear to delamination wear (25 N similar to 100 N), and finally attains the state of severe plastic deformation (125 N similar to 150 N). Under the action of normal load and friction shearing force, the deformation layer in the subsurface increases from 3 mu m to 43 mu m with increasing load, and the accumulation of strain leads to cracks and holes.
What problem does this paper attempt to address?