Abstract:Two-dimensional tungsten disulfide (WS2) nanosheets with large specific surface energies usually suffer from serious aggregation, hindering their catalytic activity and potential applications. In this work, highly dispersed WS2 nanosheets were synthesized in a cost-effective way by employing sepiolite (Sep) nanofibers as the carrier via a hydrothermal treatment followed by calcination under H2/N2 atmosphere, and the mass fraction of the raw materials including ammonium metatungstate, thioacetamide, oxalate acid and sepiolite were determined as 29.3 wt%, 35.7 wt%, 25.0 wt% and 10.0 wt%, respectively. The dispersed WS2 nanosheets were uniformly grown on the Sep, as observed by an electron microscope. First principle calculations further revealed that the favorable bonding between the tungsten of WS2 [W(WS2)] and the oxygen of Sep [O(Sep)] at the WS2/sepiolite interface enables Sep a unique support, superior to other minerals for growing such a highly-dispersed ultrathin WS2 architecture. Compared with pure WS2, the as-prepared WS2/sepiolite composite exhibits about 7 times the specific surface area and 7.4 times the photocatalytic efficiency toward rhodamine B (RhB) degradation due to the better dispersion of WS2 nanosheets and synergetic effects of sepiolite. Besides, the radical trapping experiment indicates that photo-generated hole (h+) plays the leading role, while hydroxyl radical (·OH) and superoxide radical (·O2−) act as the assistants during photocatalysis. This work provides a novel strategy for the low-cost preparation of high-quality two-dimensional materials via assembly on mineral materials.

Synthesis of high-quality WS<sub>2</sub> nanotube arrays and their photocatalytic properties

Water-Assisted Preparation of High-Purity Semiconducting (14,4) Carbon Nanotubes

Novel Route to WO<i><sub>x</sub></i>Nanorods and WS<sub>2</sub>Nanotubes from WS<sub>2</sub>Inorganic Fullerenes

Novel route to WOx nanorods and WS2 nanotubes from WS2 inorganic fullerenes.

Facile Large Scale Synthesis of WS2 Nanotubes from WO3 Nanorods Prepared by a Hydrothermal Route

A Simple Method for the Synthesis of Tungsten Trioxide Nanorods Array Without Catalyst

Hydrothermal Fabrication of Hyacinth Flower-Like WS 2 Nanorods and Their Photocatalytic Properties

Oxygen mediated growth of flower-like tungsten disulfide nanosheets as highly active photocatalysts

Cost-effective synthesis of highly-dispersed WS<sub>2</sub> nanosheets assembled on tourmaline for improved photocatalytic activity

Controllable Synthesis of WO3 Nanowires by Electrospinning and Their Photocatalytic Properties under Visible Light Irradiation

Gram‐Scale Synthesis of Ultrathin Tungsten Oxide Nanowires and their Aspect Ratio‐Dependent Photocatalytic Activity

Gram-scale wet chemical synthesis of wurtzite-8H nanoporous ZnS spheres with high photocatalytic activity

One-step Synthesis of Sulfur and Tungstate Co-Doped Porous G-C3n4 Microrods with Remarkably Enhanced Visible-Light Photocatalytic Performances

A WS2/sepiolite composite with highly dispersed WS2 nanosheets for photocatalytic wastewater treatment

Surfactant-Assisted Regulation of WS2/Tourmaline Microstructures for Excellent Photocatalytic Performance

WS2 Nanodots-Modified TiO2 Nanotubes to Enhance Visible-Light Photocatalytic Activity

Cost-effective synthesis of highly-dispersed WS2 nanosheets assembled on tourmaline for improved photocatalytic activity

Ta2O5 Nanowires: a Novel Synthetic Method and Their Solar Energy Utilization.

Synthesis of WO_3−x Nanomaterials with Controlled Morphology and Composition for Highly Efficient Photocatalysis

Sepiolite-Supported WS2 Nanosheets for Synergistically Promoting Photocatalytic Rhodamine B Degradation

A Facile Route to Synthesis of Double-Sided TiO2 Nanotube Arrays for Photocatalytic Activity