Abstract:The new power system with increasingly high renewable energy proportion necessitates the combined heating and power (CHP) generation units to provide more flexibility. With full consideration of operation characteristics, this paper firstly proposes an advanced coal-fired CHP-CAES system consisting of a 350 MW coal-fired CHP unit and a 30 MW CAES system, which realizes more efficient energy utilization and enhances the system adjusting flexibility through thermal cycles integration and energy comprehensive utilization. The thermodynamic models and multi-dimensional performance analysis models are separately established. Based on that, the comparative study is conducted for two CHP-CAES configurations and the stand-alone CHP unit. With 80% heating load, the minimum power ratio is lowered by 11.69% rated power and the maximum power output is increased by 6.35% rated power, and 27.26 tons of coal can be saved for a single cycle compared with the stand-alone CHP unit. The results also demonstrate that the system still has superiority when the load ratio changes. Techno-economic evaluations for a typical application scene show that the dynamic payback period of the proposed system is shortened by 10.41 years compared with the reference separate CHP-CAES system. These results show that the proposed system presents better performance in energy utilization, enhancing flexibility, realizing clean and low-carbon heating as well as techno-economics. In addition, parametric analysis is implemented to find the influence of CAES parameters on the system. It is found that increasing the expander inlet temperature and air storage pressure can further enhance the system round-trip performance. Yet, the investment cost increases greatly for higher storage pressure and the payback period will be lengthened. Furthermore, the system advantages are strengthened with a CAES system of greater capacity. Nevertheless, we find that the deep coupling in the thermodynamic cycle of the two systems results in an upper capacity for the integrated CAES system, and it is nearly 35 MW for the studied system. These regularities and conclusions can provide theoretical guides and directions for the customized CAES system design with the purpose to integrate with a coal-fired CHP unit.

Performance Assessment and System Optimization on Supercritical CO2 Double-Path Recompression Coal-Fired Combined Heat and Power Plants with MEA-based Post-Combustion CO2 Capture

Performance assessment and system optimization on supercritical CO 2 double-path recompression coal-fired combined heat and power plants with MEA-based post-combustion CO 2 capture

Preliminary Conceptual Exploration about Performance Improvement on Supercritical CO2 Power System Via Integrating with Different Absorption Power Generation Systems

Thermodynamic Analysis of Coal-Fired Thermal Power Units Coupled S-CO2 Energy Storage System

Thermodynamic Optimization on Supercritical Carbon Dioxide Brayton Cycles to Achieve Combined Heat and Power Generation

Exergy Analysis of a 1000 MW Single Reheat Advanced Supercritical Carbon Dioxide Coal-Fired Partial Flow Power Plant

Study on heat integration of supercritical coal-fired power plant with post-combustion CO2 capture process through process simulation

Optimization and Comparison on Supercritical CO2 Power Cycles Integrated Within Coal-Fired Power Plants Considering the Hot and Cold End Characteristics

Integration and Conversion of Supercritical Carbon Dioxide Coal-Fired Power Cycle and High-Efficiency Energy Storage Cycle: Feasibility Analysis Based on a Three-Step Strategy

Preliminary Conceptual Design and Performance Assessment of Combined Heat and Power Systems Based on the Supercritical Carbon Dioxide Power Plant

Innovative System Configuration Analysis and Design Principle Study for Different Capacity Supercritical Carbon Dioxide Coal-Fired Power Plant

Exergy Analysis of a 1000 MW Single Reheat Supercritical CO2 Brayton Cycle Coal-Fired Power Plant

Integration of Chemical Looping Combustion and Supercritical CO2 Cycle for Combined Heat and Power Generation with CO2 Capture

Energy, Exergy and Economic (3E) Analysis of a Novel Integration Process Based on Coal-Fired Power Plant with CO2 Capture & Storage, CO2 Refrigeration , and Waste Heat Recovery

Thermodynamic and Exergoeconomic Analysis of a Supercritical CO2 Cycle Integrated with a LiBr-H2O Absorption Heat Pump for Combined Heat and Power Generation

Heat Integration and Optimization of Supercritical CO2 Recompression Cycle Coupled with Oxy-Coal Combustion

Overlap Energy Utilization Reaches Maximum Efficiency for S-CO2 Coal Fired Power Plant: A New Principle

Dynamic Modeling and Comprehensive Analysis of an Ultra-Supercritical Coal-Fired Power Plant Integrated with Post-Combustion Carbon Capture System and Molten Salt Heat Storage

Process and Integration Optimization of Post-Combustion CO2 Capture System in a Coal Power Plant

Thermodynamics, flexibility and techno-economics assessment of a novel integration of coal-fired combined heating and power generation unit and compressed air energy storage

Preliminary Design Assessment of Supercritical CO2 Cycle for Commercial Scale Coal-Fired Power Plants