Self-powered Photoelectrochemical Aptasensor Based on AgInS2@Co/Ni-UiO-66@CDs Photoelectrode for Estradiosl Detection

Yuan Ruifang,Zhang Xue,Xue Xiaodong,Feng Rui,Zhao Yanxia,Sun Meng,Yan Liangguo,Yan Tao,Wei Qin
DOI: https://doi.org/10.1007/s00604-022-05409-z
IF: 5.7
2022-01-01
Microchimica Acta
Abstract:A self-powered photoelectrochemical (PEC) aptasensor was constructed to sensitively detect 17β-estradiol (E2). Firstly, a reasonable AgInS2@Co/Ni-UiO-66@Carbon Nanodots (CDs) photoelectrode with excellent photoelectrochemical performance was built by a simple two-step preparation method. The Co and Ni doping markedly improved the activity of UiO-66; the matched energy level of AgInS2 and Co/Ni-UiO-66 promoted the separation of electron–hole pairs, and the coupling of CDs further enhanced the conductivity and light utilization. Therefore, a steady anode-photocurrent signal output was obtained in 0.0 V bias voltage, providing a reliable photoelectric translating platform for assembling a self-powered PEC aptasensor. The E2-aptamer was adopted as a recognition unit to enhance the selectivity and sensitivity of the proposed aptasensor. The specific recognition reaction between E2 and aptamer administering to a raised photocurrent signal and the concentration of E2 was quantified by counting the fluctuation of the anode-photocurrent signal. The linear response range of the PEC aptasensor was 1.0 × 10−5–10 nmol/L, and the detection limit (S/N = 3) was lower than 3.0 fmol/L under optimal conditions. The fabricated aptasensor exhibited admirable selectivity, high sensitivity, rapid response, and wide linear range, demonstrating an extensive application prospect for environmental endocrine disruptor detection.
What problem does this paper attempt to address?