Abstract:Solid desiccant is subjected to remove extra humidity from unsaturated air once thermally regenerated and then sufficiently cooled down. Therefore, it can be incorporated into the traditional vapor compression (VC) systems to handle the latent heat load with elevated evaporation temperature. The condensation heat can be recovered to regenerate the desiccant periodically, with an extra bonus of overall heat transfer enhancement. Such system is named after solid desiccant heat pumps (SDHP), expectedly to deliver higher evaporation temperature and lower pressure ratio at the expenses of the periodical switchover, increased wind friction and slightly impaired sensible heat transfer performance due to the desiccant thermal resistance. To verify the feasibility and superiority of SDHPs, this article proposes a robust thermodynamic model to calculate the operational parameters in SDHPs, such as evaporation temperature, condensation temperature and electricity consumption, corresponding to specific application scenarios. An exergy analysis based on the calculated parameters then followed to identity the origin and destination of the exergy. It concludes that, SDHPs can recover the dehumidification capacity of desiccant by low-grade condensation heat (∼50 °C), with the transfer enhancement up to 120%. Meanwhile, the introduction of the solid desiccant will contribute to a 11%–169% improvement in coefficient of performance (COP) and a 52%–207% improvement in exergy efficiency, in spite of the exergy destruction by air-side friction (<5%) and switchover offset (<10%). Last but not least, for normally encountered latent heat ratio (0.2–0.5), desiccant with linear isotherms or with moderate stepwise position (35–45%) will surpass materials with earlier or later stepwise position.

Integration of Desiccant Wheels and High-Temperature Heat Pumps with Milk Spray Dryers

A Simulation Study of Heat and Mass Transfer in A Honeycombed Rotary Desiccant Dehumidifier

Experimental Analysis of a Heat Pump Dryer with an External Desiccant Wheel Dryer

Performance optimization of heat pump driven liquid desiccant dehumidification systems

Thermodynamic analysis of desiccant wheel coupled to high-temperature heat pump system

Model-based Investigation of a Heat Pump Driven, Internally Cooled Liquid Desiccant Dehumidification System

Application Of Heat Pump-Driven Two-Stage Desiccant Wheel System In Office Buildings

Performance Investigation of a Constant Temperature Heat Pump Dryer

An exergy analysis and parameter optimization of solid desiccant heat pumps recovering the condensation heat for desiccant regeneration and heat transfer enhancement

Performance Investigation of a Counter-Flow Heat Pump Driven Liquid Desiccant Dehumidification System

Performance Analysis of A New Kind of Heat Pump-Driven Outdoor Air Processor Using Solid Desiccant

Experimental and Theoretical Assessment of a Solar Assisted Heat Pump System for In-Bin Grain Drying: A Comprehensive Case Study

Performance analysis of a two-stage desiccant cooling system

Irreversible Processes and Performance Improvement of Desiccant Wheel Dehumidification and Cooling Systems Using Exergy

Effect of drying air supply temperature and internal heat exchanger on performance of a novel closed-loop transcritical CO 2 air source heat pump drying system

Optimization of a rotary desiccant wheel for enthalpy recovery of air-conditioning in a humid hospitality environment

Heat and Mass Transfer Analysis and Performance Comparison for Different Solid Dehumidification Methods

Performance investigation and exergy analysis of air-handling processes using liquid desiccant and a desiccant wheel

Heat and mass transfer model for desiccant solution regeneration process in liquid desiccant dehumidification system

Break-even of high-temperature heat pump integration for milk spray drying

Dynamic model and response characteristics of liquid desiccant air-conditioning system driven by heat pump